Category: Audio
Subcategories
There are 279 products.
Class A power amplifier with one channel, 10 W. Built on the popular design of J. Hood from 1969. The set includes 2 pieces for self-assembly
Module with PDM microphone. It allows you to receive a sound signal and send it using PDM modulation. Adafruit 3492
LM386 mono digital audio amplifier module. The system allows you to connect a loudspeaker with a power of up to 10 W. Kit for self-assembly
Audio module designed for Teensy 4.0 and 4.1. It uses the SGTL500 audio codec chip with I2S interface, it can work with a microSD card or SPI Flash memory. Audio Adapter Boards for Teensy 4.x (Rev D)
Pmod I2S2 is a module with 24-bit A / C and D / C audio converters derived from standard 3,5 mm Jack connectors. Thanks to them, it is possible to send and receive stereo audio signals using the I2S protocol. Digilent 410-379
Audio module with WM8960 stereo codec. It allows you to record sounds and play them. Waveshare 15019
Module dedicated to the audio preamplifier with DIP8 socket for NE5532, OPA2134, OPA2604 or AD826 chips
A module with a MEMS microphone that will allow you to detect a voice, a clap or a door slam. The board has an analog output. DFRobot SEN0487
Gravity: UART MP3 Voice Module is an MP3 sound player module with a built-in 8 MB memory. It is powered by 3.3-5V and controlled by the UART interface. DFRobot DFR0534
Stereo audio level indicator module. Equipped with 32 blue LEDs (16 per channel)
2-channel stereo audio mixer in a metal housing. It has four outputs, on which the summed signal from 2 inputs is available. It is powered with the voltage from 5 to 19 V
Single-channel audio amplifier up to 100 W.
A sound card in the form of a small device with a USB plug, designed to work with the Raspberry Pi and NVIDIA Jetson Nano minicomputer. Waveshare USB TO AUDIO
Stereo audio isolator based on two transformers. It allows to eliminate noise in the audio path resulting from different ground resistances of the sound source and the receiver. XH-M372
Expansion board compatible with STM32 Nucleo. Allows you to prototype solutions with digital microphones. STMicroelectronics X-NUCLEO-CCA02M2
4-channel input selector for audio amplifier. Equipped with RCA connectors and controlled by a rotary switch
4-channel stereo audio mixer module. It has one output to which the summed signal from 4 inputs comes out. It is powered with the voltage from 5 to 12 V
Crossover for woofers with a division frequency of 300 Hz. Works with 4 to 8 ohm speakers and offers up to 200 watts of power
TDA7266 stereo digital audio amplifier module. The system allows you to connect two speakers with an impedance of 4 to 8 Ω and a power of 7 W