Nova PM100 laser particle sensor
ID: 577483
5906623457427
zł435.31
Tax included
zł353.91 tax excl.
Total suspended particulate (TSP) sensor that allows you to measure the particle concentration from 1 to 100 μm. SDS198
Description
Total suspended particulate (TSP) sensor, using principle of laser scattering, can get the particle concentration between 1 to 100μm in the air. The sensor can communicate with the microcontroller via the UART interface or via a configurable output port. The laser diode used in the sensor is of high quality and allows trouble-free operation even for 8000 hours of continuous working, this time can be significantly extended by reducing the frequency of measurements.
Pin connections
| No. | Name | Comment |
| 1 | NC | Not Connect |
| 2 | 1μm | Reserved |
| 3 | 5V | 5V Input |
| 4 | 2,5μm | Reserved |
| 5 | GND | Ground |
| 6 | R | RX interface UART（TTL）@3.3V |
| 7 | T | TX interface UART（TTL）@3.3V |
Features
- Measuring range: 0-20 mg / m3
- Measurement sensitivity: 1 μg / m3
- Working voltage: 5V
- Logical voltage of the UART interface: 3.3 V
- Current consumption: 70 mA ± 10 mA
- Power consumption in standby mode: <4mA
- Working temperature: -10 ~ +50 ℃
- Storage temperature: -20 ~ +60 ℃
- Maximum working humidity: 70%
- Maximum storage humidity: 90%
- Maximum relative error: ± 20% ± 30 μg / m3
- Supply voltage: 4.7 - 5.3 V
- Dimensions: 71 x 70 x 23 mm
- Compliance with certificates: CE, FCC, RoHS
577483
Data sheet
- Interface
- UART
- Type of sensor
- inny
- Power supply voltage
- 5 V
- Concentration measurement
- PM1 - PM100
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface
zł53.71
24h
Available quantity: 20
Available
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
zł108.42
Delivery date unknown
No product available!
The latest version of the Raspberry Pi series: Raspberry Pi 4 model B with quad-core SoC (Broadcom BCM2711, Cortex-A72) working at 1.8GHz, 2GB RAM LPDDR4, Broadcom VideoCore VI.
zł220.90
Delivery date unknown
No product available!
The long-awaited Raspberry Pi 4 model B with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.8 GHz, 4 GB LPDDR4 RAM and the Broadcom VideoCore VI graphics chip
zł276.75
Delivery date unknown
No product available!
Development board with SAMD21 microcontroller (ARM Cortex® M0+), 8 I/O lines, 12 PWM channels, micro-USB. The board is equipped with an ESP32 module enabling the implementation of communication via WiFi. Arduino MKR WiFi 1010 ABX00023
zł178.01
Delivery date unknown
No product available!
Board with nRF52840 microcontroller with Cortex M4F core (64 MHz, 1 MB Flash, 256 kB RAM). Equipped with BT 5.0 and IMU LSM9DS1 module. Module with headers. Arduino ABX00034
zł179.00
24h
Available quantity: 20
Available
Other products in the same category (16)
Air quality sensor module PMSA003. It allows you to analyze the amount of pollutants based on the concentration of PM1.0, PM2.5 and PM10 particles. SB Components 21208
zł215.73
24h
Available quantity: 1
Available
The module allows the detection of volatile organic compounds (VOC) in the air, based on Winsen\'s WSP2110 system. Allows for detection in the air; formaldehyde (HCHO), methane, benzene, toluene, alcohol, etc. The sensor output is an analog signal. Seeed studio 101020001
zł79.32
24h
Available quantity: 4
Available
Laser sensor of air pollution with particles PM1,0, PM2.5 and PM10. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. Data is output to the UART interface. PMS3003
zł95.25
24h
Available quantity: 38
Available
Air quality sensor module based on the ENS160 system. It communicates via the I2C or SPI interface. DFRobot SEN0515
zł69.22
24h
Available quantity: 2
Available
Dust Sensor, A simple Air Monitor
zł58.90
24h
Available quantity: 3
Available
Module with environmental sensors for Raspberry Pi Pico. It allows you to measure temperature, humidity, air quality pressure and color detection. SB Components 22366
zł208.80
24h
Available quantity: 3
Available
The sensor is designed for indoor air quality testing. The main gas detected is carbon monoxide, alcohol, acetone, thinner, formaldehyde and other slightly toxic gases. It is compatible with 5V and 3.3V power supply. Seeed Studio 101020078
zł58.12
24h
Available quantity: 3
Available
ENS160 gas sensor module to measure the concentration of carbon dioxide (eCO2) and volatile organic compounds (TVOC) in the air. It communicates via an I2C or SPI interface. SparkFun SEN-20844
zł119.84
24h
Available quantity: 3
Available
The SCD-40 CO2, temperature and humidity sensor module provides high accuracy readings. It is equipped with a Qwiic connector and communicates via an I2C interface. SparkFun SEN-22395
zł484.35
24h
Available quantity: 1
Available
Sensirion\'s SEN54 sensor module, which combines a sensor that allows measurement of particulate matter, VOCs, humidity and temperature in a single housing. SparkFun SEN-19325
zł230.58
3 weeks
No product available!
Module with a BME688 sensor for measuring gas concentration, pressure, temperature and humidity. I2C or SPI communication. SparkFun SEN-19096
zł196.21
24h
Available quantity: 3
Available
Module with SGP30 gas sensor. The sensor communicates via the I2C interface. SGP30 system contains several elements reacting to various metal oxides, which allows for more accurate determination of air quality. Adafruit 3709
zł111.60
24h
Available quantity: 1
Available
Module with gas sensor designed to monitor indoor air quality. It was based on the AMS CCS811 system that allows the detection of volatile organic compounds (VOCs) in the air. Digilent 410-386
zł174.70
24h
Available quantity: 1
Available
Module with air quality sensor SGP30. It allows you to read the concentration of VOC (TVOC) and eCO2 and communicates via the I2C interface. Pimoroni PIM480
zł102.93
24h
Available quantity: 1
Available
Sharp GP2Y1010AU0F dust and particle concentration sensors. It is supplied with the voltage from 5 to 7V. Has an analog output. DFRobot SEN0144
zł61.46
24h
Available quantity: 4
Available
The PMSA003 air quality sensor module is designed for the Raspberry Pi. It allows you to analyze the amount of pollutants based on the concentration of PM1.0, PM2.5 and PM10 particles. SB Components 20768
zł247.80
24h
Available quantity: 1
Available
Total suspended particulate (TSP) sensor that allows you to measure the particle concentration from 1 to 100 μm. SDS198