Best sellers
There are 15481 products.
A 20 cm long 4-pin cable with a JST XH2.5 female plug on one side
STM32 Nucleo-64 development board with STM32F303RET6 MCU, supports Arduino and ST morpho connectivity
Compact tool for debugging and programming STM32 microcontrollers via JTAG / SWD interfaces. STMicroelectronics STLINK-V3MINIE
Frequency generator module with Si5351 chip based on 25 MHz quartz. The system has three independent, programmable clock outputs that can generate a clock signal in a wide range from 8 kHz to 160 MHz
The KAmod USB-C Adapter Module allows for the connection of a USB-C port to almost any electronic system. The pin header provides only the essential signals, including 5V power and D+ and D- data lines.
ARK terminal connector with a fuse, 5-pin, pitch 10.00 mm, non-detachable
The official power supply for Raspberry Pi 4 model B with 5.1V output voltage and 3A current efficiency. It has a USB-C plug. Black power supply.
10 mm Ultra White LED, 10 degree angle; light intensity 25000 mcd (20mA) (3.2V)
2p male plug angled for PCBs, 2.54mm thick, tinned, white color. Set of 10 pieces
A set of two 35mm crocodile clips (terminals) with a black and red cover.
The FFC/FPC cable with 22 pins, a 0.5 mm pitch, and a length of 30 cm type A-B is a flexible flat cable. Its design enables reliable connections in electronic devices with limited space, such as laptops, tablets, and cameras.
THT resistor, 0.25W, 5%, RoHS
A specialized liquid intended for cleaning cartridges and nozzles of all types of inkjet printers. MICRO CHIP ELECTRONIC ART.167
Bent tweezers, 115 mm long, made of stainless steel, with a hardness of 30 HRC on the Rockwell scale, is antimagnetic and resistant to acids. Yato YT-6907
ST7 MCU, 4kB Flash, 384B RAM, 128B EEPROM, LQFP32, RoHS
UART - USB converter based on the FT232RL chip with TX, RX, RTS and CTS lines led out to the pin connector, the remaining lines available on solder fields for pin connectors. Micro-USB socket. Voltage supply from 3.3 to 5 V. FT232 USB UART Board (micro)
The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. Soldered connectors. KApico RP2040
LSF0204PWR, 4-Bit Bidirectional Multi-Voltage Level Translator for Open-Drain & Push- Pull, TSSOP14