Products
Categories
- Main categories
-
- 3D PRINTING
- ACADEMIC OFFER
- ARDUINO
- AUTOMATION
- BOOKS
- DIY KITS
- AVT kits
- Audio
- Car
- Chargers
- Clocks, timers and schedule switches
- Communication
- Converters
- Development kits and modules
- Displays
- Electronic games
- Generators
- Hobbies and fun
- House
- Interfaces
- Light effects
- meters
- PC
- Power Supplies
- Pre-programmed circuits
- Printed circuit boards (PCB)
- Programmers
- Regulators, controllers
- Remote control
- Starter sets Ośla Łączka
- Starting sets for beginners
- Workshop tools
- Audio
- Other sets
- TOP-Q kits
- Totem
- UGears
- Velleman
- AVT kits
- EBOOKS
- ELECTRONICS
- Cables
- Cameras and accessories
- Communication
- Conductive materials
- Connectors
- ARK connectors (Terminal Block)
- Coaxial connectors (RF)
- Connectors
- Crocodile clip
- D-Sub drawer connectors
- DC power connectors
- FFC/FPC ZIF connectors
- Goldpin connectors
- IDC connectors
- JACK connectors
- JST connectors
- Jumpers
- Memory cards slots
- Other connectors
- Pogo pin
- RJ45 sockets
- Slip ring connector
- Supports
- Szybkozłącza
- USB connectors
- Cooling
- Displays
- Electronic modules
- A/D and D/A converters
- Audio
- Barcode readers
- CAN converters
- Converters USB - UART / RS232
- Data logger
- DDS/PLL generators
- Digital potentiometers
- Encoders
- Expanders of the I/O
- Fingerprint readers
- HMI modules
- Image and video
- JTAG accessories
- Keyboards, buttons
- LED drivers
- Memory card readers
- Memory modules
- Modules with power outputs
- Motor controllers
- Power modules
- RS485 converters
- RTC modules
- Servo Controllers
- TSOP infrared receivers
- USB Converters - I2C / 1-Wire / SPI
- Voltage converters
- Gadgets
- GPS
- Intelligent clothes
- LED - diodes, displays, stripes
- Luminous wires and accessories
- Memory cards and other data storages
- Passive elements
- PC accessories
- Printers
- Prototype boards
- Semiconductors
- A/C converters (ADC)
- Analog systems
- Audio systems
- Bridge rectifiers
- Button
- D/A Converters (DAC)
- DDS synthesizers
- Digital circuits
- Diodes
- Drivers of motors
- DSP microprocessors
- Energy counters
- Energy harvesting
- ESD security
- IGBT drivers and bridges
- Interface systems
- LED drivers
- Logic converters
- Memory
- Microcontrollers
- Optotriacs and optocouplers
- Other
- PLL generators
- Power systems
- Programmable systems
- Resetting systems
- RF systems
- RTC systems
- Sensors
- SoC systems
- Timery
- Touch sensors
- Transistors
- Sensors
- Accelerometers
- Air humidity sensors
- Air quality sensors
- Current sensors
- Distance sensors
- Flow sensors
- Gas sensors
- Gyroscopes
- Hall sensors
- Humidity sensors
- Infrared sensors
- Light and color sensors
- Liquid level sensors
- Magnetic sensors (compasses)
- Medical sensors
- Motion sensors
- PH sensors
- Position sensors
- Pressure sensors
- Pressure sensors
- Reflection sensors
- Sensors 6DOF/9DOF/10DOF
- Sensors of liquid quality
- Temperature sensors
- Vibration sensors
- Sound transducers
- Switches and buttons
- Cables
- INTERNET OF THINGS (IoT)
- MECHANICS
- POWER
- R/C MODELLING
- RASPBERRY PI
- Accessories for Raspberry Pi
- Audio video cables for Raspberry Pi
- Case Raspberry Pi
- Cooling for Raspberry Pi
- Displays for Raspberry Pi
- Extension modules for Raspberry Pi
- Memory cards for Raspberry Pi
- Power for Raspberry Pi
- Raspberry Pi 3 model A+
- Raspberry Pi 3 model B
- Raspberry Pi 3 model B+
- Raspberry Pi 4 model B
- Raspberry Pi 400
- Raspberry Pi 5
- Raspberry Pi cameras
- Raspberry Pi Compute Module
- Raspberry Pi model A/ B+/2
- Raspberry Pi Pico
- Raspberry Pi prototyping
- Raspberry Pi Zero
- Raspberry Pi Zero 2 W
- RETIRED PRODUCTS
- ROBOTICS
- SALE
- SOFTWARE
- STARTER KITS, PROGRAMMERS, MODULES
- Alchitry FPGA
- Altera FPGA
- Analog electronics
- Atmel SAM
- Atmel Xplain
- AVR
- Banana Pi
- BeagleBone
- chipKIT
- Coral
- CPLD Xilinx
- Cubieboard
- DFRobot FireBeetle
- Feather
- Freedom (Kinetis)
- FriendlyELEC
- HummingBoard
- Intelligent clothes
- Kit with a book
- LattePanda
- LPC (NXP)
- M5Stack
- Micro:bit
- Nvidia Jetson
- Odroid
- ODYSSEY
- Orange Pi
- Other development kits
- Peripheral modules
- PIC
- Raisonance
- Raspberry Pi RP2040
- RFID
- RISC-V
- SBC Embest
- SBC MYIR
- SBC others
- SBC UDOO
- Segger programmers
- SoMLabs
- Sparkfun MicroMod
- STM32
- STM32 Discovery
- STM32 MP1
- STM32 Nucleo boards
- STM8
- Teensy
- Universal programmers
- WRTNode
- Xilinx FPGAs
- WORKSHOP
- Adhesives and gluers
- Anti-static mats (ESD)
- Chemistry
- CNC milling machines
- Crimping tools
- Dispensing needles
- Drills
- Files
- Generators
- Handles, magnifiers
- Heat-shrink tubing
- Insulation strippers
- Keys
- Knives and scissors
- Laboratory power supplies
- Laminates
- Measuring devices
- Mikroskopy
- Mini drills and grindrers
- Organizers
- Oscilloscopes and accessories
- Pliers and pincers
- Power tools
- Riveting tools and rivets
- Screwdrivers
- SMD Accessories
- Soldering
- Tapes (aluminum, kapton, copper, insulating)
- Tweezers
- Ultrasonic cleaners
- Vices
- 3D PRINTING
New products
New products
zł306.51 tax excl.
Base board dedicated to Raspberry Pi CM4 modules. It is equipped with two cameras with an IMX219 sensor with a resolution of 8 MP. Interface expander included. Waveshare CM4-DUAL-CAMERA-BASE-Acce-A
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
Set with Dual Camera Base and interface expander for Raspberry Pi CM4 modules.
The Dual Camera Base board is equipped with special connectors for connecting the CM4 module and the output of the basic interfaces, including USB, Ethernet, HDMI and a microSD card slot. In addition, there are two FFC connectors, on which USB 2.0, PCIe, HDMI and GPIO interfaces are available. They are used to connect the RPi CM4 to the interface expander. On the other side of the board, the user has two cameras with an IMX219 sensor with a resolution of 8 MP (3280 x 2464 px).
Interface Expander is a module that extends the capabilities of the Dual Camera Base. It allows the use of other interfaces which, due to their small size, were not led out on the base board. The expander also provides three USB 2.0 sockets, an HDMI port and a 40-pin GPIO connector compatible with HAT modules. There is also an M.2 connector on the board for connecting additional communication modules or a disk. The Interface Expander connects to the Dual Camera Base using the two FFC tapes included in the kit.
The set is dedicated to applications using stereo vision, including image recognition in autonomous driving systems or robotics. Full documentation is available on the product Wiki page.
Features
Dual Camera Base
- CM4 connector: suitable for all variants of the Raspberry Pi CM4 module (not included)
- HDMI connector with 4K 30fps support
- RJ45 Gigabit Ethernet connector
- USB 2.0 connector
- USB type C connector for power and programming
- MicroSD card slot
- FFC (GPIO) connector
- FFC connector (HDMI, PCIe, USB)
- 2 x camera with IMX219 sensor
- Resolution: 8 MP, 3280 x 2464 px
- Optical CMOS Size: 1/4"
- Aperture: F2.4
- Focal length: 2.6 mm
- Viewing angle (FOV): 83/73/50°
- Distortion: <1%
- Power supply: USB type C, 5V/2.5A
- Dimensions: 85 x 51.5 mm
Interface Expander
- Standard 40-pin Raspberry Pi HAT connector
- 3 x USB 2.0 connectors
- FFC (GPIO) connector
- FFC connector (HDMI, PCIe, USB)
- M.2 M KEY jack
- HDMI connector with 4K 30fps support
- Dimensions: 85 x 51.5 mm
Kit contains
- Dual Camera Base module
- A set of screws
- Interface Expander
- 2 x FFC tape
You might also like
SoM Raspberry Pi CM4 with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5 GHz, 1 GB LPDDR4 RAM and 8 GB eMMC. Raspberry Pi CM4001008
No product available!
SoM Raspberry Pi CM4 Lite with quad-core SoC Broadcom BCM2711 (4 x Cortex-A72) operating at 1.5 GHz clock speed, 2 GB LPDDR4 RAM memory and wireless connectivity. Raspberry Pi CM4102000
No product available!
SoM Raspberry Pi CM4 with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5 GHz, 2 GB LPDDR4 RAM, 16 GB eMMC and wireless connectivity. Raspberry Pi CM4102016
SoM Raspberry Pi CM4 Lite with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5 GHz, 4 GB LPDDR4 RAM. Raspberry Pi CM4004000
Base board dedicated to Raspberry Pi CM4 modules. It is equipped with two cameras with an IMX219 sensor with a resolution of 8 MP. Waveshare CM4-DUAL-CAMERA-BASE
Other products in the same category (16)
Base board dedicated to Raspberry Pi CM4 modules. It is equipped with two Ethernet connectors, a microSD slot and a USB connector. It allows you to build a router. Seeed Studio 103110042
Kit with base board for Raspberry Pi CM4. Equipped with an LCD display with a touch panel, a 5 MP camera and a set of connectors. Waveshare CM4-DISP-BASE-7A-BOX-EU
A base board dedicated to Raspberry Pi CM4 modules. It is equipped with two RJ45 connectors, USB 2.0 and a microSD slot. In addition, there is a fan connector on the board. Waveshare CM4-DUAL-ETH-MINI-BOX (EU)
No product available!
A set for building a minicomputer based on Raspberry Pi CM4. It consists of a metal housing with a fan, a power supply and a Dual Gigabit Ethernet 5G/4G Base Board. Waveshare CM4-DUAL-ETH-4G/5G-BOX-EU
Base board dedicated to Raspberry Pi CM4 modules. Equipped with a 5 "IPS LCD display with a touch panel. Waveshare CM4-DISP-BASE-5A
No product available!
Kit with IPS 13.3" LCD display dedicated to Raspberry Pi CM4 modules. It allows you to build a portable minicomputer. Waveshare 13.3inch PiPad C4 (EU)
No product available!
Kit with base board for Raspberry Pi CM4. It allows you to connect modules with 4G, 5G or LoRa communication via the M.2 B Key or Mini-PCIe connector. Waveshare CM4-IO-WIRELESS-BASE
A set for building a minicomputer based on Raspberry Pi CM4. It consists of a metal casing with a fan, a power supply and a base plate. It has the function of a UPS. Waveshare CM4-POE-UPS-BOX (EU)
Miniature camera module with OV5647 5MP sensor dedicated to Raspberry Pi Zero and Compute Module. Equipped with a lens with a viewing angle of 72°. ArduCAM B006603
Portable game console based on Raspberry Pi CM3+ Lite, equipped with LCD IPS 2.8" display, battery and speaker. Waveshare GPM2803P0
No product available!
PCIe connector adapter to 4 USB 3.2 Gen1 slots designed to work with Raspberry Pi CM4 modules. It allows you to connect devices with a USB connector to the base board via a PCIe connector. Waveshare PCIe TO USB 3.2 Gen1 (B)
A set for building a minicomputer based on Raspberry Pi CM4. It consists of a metal housing with a fan, a power supply and a Compute Module 4 PoE Board. Waveshare CM4-IO-POE-BOX-A
No product available!
A kit for building a NAS server based on the Raspberry Pi CM4 module. It has space for mounting two 2.5" SATA drives and an LCD display for monitoring the minicomputer\'s operating status. Waveshare CM4-NAS-Double-Deck (EU)
Miniature camera module with OV5647 5MP sensor dedicated to Raspberry Pi Zero and Compute Module. Equipped with a lens with a viewing angle of 120°. ArduCAM B006604
4-channel PCIe port expander. It can be powered with 12 V via a PCIe connector or an external DC connector. Waveshare PCIe-Packet-Switch-4P
Adapter with 40-pin RPi socket and CM3 SODIMM connector. It allows you to connect the Raspberry Pi Zero 2 W minicomputer to the base boards dedicated to CM3 modules. Waveshare Zero-to-CM3-Adapter