New products
New products
Available
Available
Available
Available
Available
Available
2-CH CAN HAT - CAN module for Raspberry Pi
ID: 1182296
5906623425051
zł93.38
Tax included
zł75.92 tax excl.
HAT module designed for Raspberry Pi minicomputer. Powala adds two CAN interfaces to the project. Waveshare 2-CH CAN HAT
Description
HAT expansion module dedicated to Raspberry Pi minicomputers. The board houses a CAN controller based on MCP2515 and SN65HVD230 chips, which allows you to add two CAN interfaces to your project. It is powered by 5 V, and the protection and isolation used ensures proper operation of the device even in the event of signal interference. The module communicates with the Raspberry Pi via an SPI interface with a voltage level of 3.3 V or 5 V. It will find use in industrial applications for communication between system components. Full documentation is available on the product page.
Features
- Standard Raspberry Pi GPIO 40-pin connector
- 2 x CAN bus
- MCP2515 and SN65HVD230 controller
- Built-in power isolation
- Built-in TVS (Transient Voltage Suppressor) diode, effectively suppresses surges
- Built-in 120 ohm resistor, incorporated into the circuit by jumper settings
- Operating voltage: 3.3 V/5 V
- Dimensions: 65 x 56.5 mm
Kit contains
- 2-CH CAN HAT module
- Female connector 2x20 pins
- Set of screws
1182296
Data sheet
- Compatible with
- Raspberry Pi 5/4/3/2/1 A/B, Zero/Zero 2 H/WH
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
The latest version of the Raspberry Pi series: Raspberry Pi 4 model B with quad-core SoC (Broadcom BCM2711, Cortex-A72) working at 1.5GHz, 1GB RAM LPDDR4, Broadcom VideoCore VI layout.
zł176.00 24hAvailable quantity: 146 AvailableThe latest version of the Raspberry Pi series: Raspberry Pi 4 model B with quad-core SoC (Broadcom BCM2711, Cortex-A72) working at 1.5GHz, 2GB RAM LPDDR4, Broadcom VideoCore VI.
zł220.99 Delivery date unknown No product available!
The long-awaited Raspberry Pi 4 model B with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5GHz, 4 GB LPDDR4 RAM and the Broadcom VideoCore VI graphics chip
zł277.00 24hAvailable quantity: 166 AvailableThe long-awaited Raspberry Pi 4 model B with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5GHz, 8 GB LPDDR4 RAM and the Broadcom VideoCore VI graphics chip
zł362.90 24hAvailable quantity: 12 Available
Other products in the same category (16)
Expansion board with LoRaWAN SX1303 and GNSS L76B dedicated to the Raspberry Pi. The kit includes the 868M antenna, GPS and cables. Waveshare SX1303 868M LoRaWAN Gateway HAT
zł479.63 4 weeks No product available!
Kit with the LTE Cat-6 EM06-E module designed to work with the Raspberry Pi minicomputer. It supports communication within the fast LTE-A network and GNSS positioning.Waveshare RM500U-CN 5G HAT (EU)
zł640.17 24hAvailable quantity: 1 AvailableThe KAmodRPi UART RS485 ISO is an advanced RS485 bus transceiver for the Raspberry Pi, featuring automatic transmission direction control, galvanic isolation, surge protection, and support for up to 128 modules at a transmission speed of up to 500 kbps, powered by 5V with low power consumption
zł67.70 24hAvailable quantity: 174 AvailableHAT designed for Raspberry Pi minicomputers with a two-channel RS232 converter. Communication is realized via the SPI interface. The overlay uses a standard 40-pin Raspberry Pi connector. Waveshare 2-CH RS232 HAT
zł77.86 24hAvailable quantity: 2 AvailableExpansion board with LoRa E22-900T22S module for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 868 MHz frequency band. SB Components 22571
zł159.90 Delivery date unknown No product available!
GSM/GNSS expansion module dedicated to Raspberry Pi minicomputers. Allows to equip RPi with LTE Cat-1/3G/2G communication and positioning within GPS, BeiDou, Glonass, GALILEO, QZSS navigation systems. Waveshare SIM7600E LTE Cat-1 HAT
zł255.75 4 weeks No product available!
Radio module with RFM69HCW 433 MHz chip, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4073
zł144.14 24hAvailable quantity: 2 Available4 Port USB HUB HAT for Raspberry Pi B+, Raspberry Pi 2 B, Rapsberry Pi 3 B; USB to UART Onboard. Waveshare USB HUB HAT
zł35.36 24hAvailable quantity: 10 AvailableHAT module designed for the Raspberry Pi minicomputer. It allows you to add an RS485 interface and a CAN bus to the project, allowing for wired communication of many devices over long distances. SB Components 21444
zł102.90 24hAvailable quantity: 1 AvailableHAT with 2-channel CAN converter designed for Raspberry Pi minicomputers. The communication was based on the CAN controller MCP2518FD as well as the MCP2562FD transceiver and SPI interface. Waveshare 2-CH CAN FD HAT
zł209.40 24hAvailable quantity: 10 AvailableExpansion board with LoRa E22-400T22S module for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 433 MHz frequency band. Waveshare SX1268 433M LoRa HAT
zł95.96 4 weeks No product available!
Expansion board with LoRa Node SX1262 module dedicated for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 433 MHz frequency band. Waveshare SX1262 433/470M LoRaWAN HAT
zł74.03 24hAvailable quantity: 2 AvailableExpansion board with LoRa Node SX1262 module dedicated for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 868 MHz frequency band. Waveshare SX1262 868/915M LoRaWAN HAT
zł74.49 24hAvailable quantity: 1 AvailableThe Quectel 5G RM520N-GL module kit is designed for use with the Raspberry Pi minicomputer. It supports 5G SA or NSA networks and is backwards compatible with 4G and 3G networks. Waveshare RM520N-GL 5G HAT (with case) (EU)
zł1,345.98 24hAvailable quantity: 1 AvailableA NFC-compatible Raspberry Pi expansion kit with integrated antent. It has the ability to work in reader mode, P2P
and card emulation mode. NXP PN7150Regular pricezł149.00zł129.00 24hAvailable quantity: 4 AvailableA 3-port HUB module with a USB 3.2 Gen1 interface with an RJ45 connector designed to work with the Raspberry Pi minicomputer. Waveshare USB 3.2 Gen1 HUB Gigabit ETH HAT
zł117.31 24hAvailable quantity: 3 Available
HAT module designed for Raspberry Pi minicomputer. Powala adds two CAN interfaces to the project. Waveshare 2-CH CAN HAT