Products
Categories
- Main categories
-
- 3D PRINTING
- ACADEMIC OFFER
- ARDUINO
- AUTOMATION
- BOOKS
- DIY KITS
- AVT kits
- Audio
- Car
- Chargers
- Clocks, timers and schedule switches
- Communication
- Converters
- Development kits and modules
- Displays
- Electronic games
- Generators
- Hobbies and fun
- House
- Interfaces
- Light effects
- meters
- PC
- Power Supplies
- Pre-programmed circuits
- Printed circuit boards (PCB)
- Programmers
- Regulators, controllers
- Remote control
- Starter sets Ośla Łączka
- Starting sets for beginners
- Workshop tools
- Audio
- Other sets
- TOP-Q kits
- Totem
- UGears
- Velleman
- AVT kits
- EBOOKS
- ELECTRONICS
- Cables
- Cameras and accessories
- Communication
- Conductive materials
- Connectors
- ARK connectors (Terminal Block)
- Coaxial connectors (RF)
- Connectors
- Crocodile clip
- D-Sub drawer connectors
- DC power connectors
- FFC/FPC ZIF connectors
- Goldpin connectors
- IDC connectors
- JACK connectors
- JST connectors
- Jumpers
- Memory cards slots
- Other connectors
- Pogo pin
- RJ45 sockets
- Slip ring connector
- Supports
- Szybkozłącza
- USB connectors
- Cooling
- Displays
- Electronic modules
- A/D and D/A converters
- Audio
- Barcode readers
- CAN converters
- Converters USB - UART / RS232
- Data logger
- DDS/PLL generators
- Digital potentiometers
- Encoders
- Expanders of the I/O
- Fingerprint readers
- HMI modules
- Image and video
- JTAG accessories
- Keyboards, buttons
- LED drivers
- Memory card readers
- Memory modules
- Modules with power outputs
- Motor controllers
- Power modules
- RS485 converters
- RTC modules
- Servo Controllers
- TSOP infrared receivers
- USB Converters - I2C / 1-Wire / SPI
- Voltage converters
- Gadgets
- GPS
- Intelligent clothes
- LED - diodes, displays, stripes
- Luminous wires and accessories
- Memory cards and other data storages
- Passive elements
- PC accessories
- Printers
- Prototype boards
- Semiconductors
- A/C converters (ADC)
- Analog systems
- Audio systems
- Bridge rectifiers
- Button
- D/A Converters (DAC)
- DDS synthesizers
- Digital circuits
- Diodes
- Drivers of motors
- DSP microprocessors
- Energy counters
- Energy harvesting
- ESD security
- IGBT drivers and bridges
- Interface systems
- LED drivers
- Logic converters
- Memory
- Microcontrollers
- Optotriacs and optocouplers
- Other
- PLL generators
- Power systems
- Programmable systems
- Resetting systems
- RF systems
- RTC systems
- Sensors
- SoC systems
- Timery
- Touch sensors
- Transistors
- Sensors
- Accelerometers
- Air humidity sensors
- Air quality sensors
- Current sensors
- Distance sensors
- Flow sensors
- Gas sensors
- Gyroscopes
- Hall sensors
- Humidity sensors
- Infrared sensors
- Light and color sensors
- Liquid level sensors
- Magnetic sensors (compasses)
- Medical sensors
- Motion sensors
- PH sensors
- Position sensors
- Pressure sensors
- Pressure sensors
- Reflection sensors
- Sensors 6DOF/9DOF/10DOF
- Sensors of liquid quality
- Temperature sensors
- Vibration sensors
- Sound transducers
- Switches and buttons
- Cables
- INTERNET OF THINGS (IoT)
- MECHANICS
- POWER
- R/C MODELLING
- RASPBERRY PI
- Accessories for Raspberry Pi
- Audio video cables for Raspberry Pi
- Case Raspberry Pi
- Cooling for Raspberry Pi
- Displays for Raspberry Pi
- Extension modules for Raspberry Pi
- Memory cards for Raspberry Pi
- Power for Raspberry Pi
- Raspberry Pi 3 model A+
- Raspberry Pi 3 model B
- Raspberry Pi 3 model B+
- Raspberry Pi 4 model B
- Raspberry Pi 400
- Raspberry Pi 5
- Raspberry Pi cameras
- Raspberry Pi Compute Module
- Raspberry Pi model A/ B+/2
- Raspberry Pi Pico
- Raspberry Pi prototyping
- Raspberry Pi Zero
- Raspberry Pi Zero 2 W
- RETIRED PRODUCTS
- ROBOTICS
- SALE
- SOFTWARE
- STARTER KITS, PROGRAMMERS, MODULES
- Alchitry FPGA
- Altera FPGA
- Analog electronics
- Atmel SAM
- Atmel Xplain
- AVR
- Banana Pi
- BeagleBone
- chipKIT
- Coral
- CPLD Xilinx
- Cubieboard
- DFRobot FireBeetle
- Feather
- Freedom (Kinetis)
- FriendlyELEC
- HummingBoard
- Intelligent clothes
- Kit with a book
- LattePanda
- LPC (NXP)
- M5Stack
- Micro:bit
- Nvidia Jetson
- Odroid
- ODYSSEY
- Orange Pi
- Other development kits
- Peripheral modules
- PIC
- Raisonance
- Raspberry Pi RP2040
- RFID
- RISC-V
- SBC Embest
- SBC MYIR
- SBC others
- SBC UDOO
- Segger programmers
- SoMLabs
- Sparkfun MicroMod
- STM32
- STM32 Discovery
- STM32 MP1
- STM32 Nucleo boards
- STM8
- Teensy
- Universal programmers
- WRTNode
- Xilinx FPGAs
- WORKSHOP
- Adhesives and gluers
- Anti-static mats (ESD)
- Chemistry
- CNC milling machines
- Crimping tools
- Dispensing needles
- Drills
- Files
- Generators
- Handles, magnifiers
- Heat-shrink tubing
- Insulation strippers
- Keys
- Knives and scissors
- Laboratory power supplies
- Laminates
- Measuring devices
- Mikroskopy
- Mini drills and grindrers
- Organizers
- Oscilloscopes and accessories
- Pliers and pincers
- Riveting tools and rivets
- Screwdrivers
- SMD Accessories
- Soldering
- Tapes (aluminum, kapton, copper, insulating)
- Tweezers
- Ultrasonic cleaners
- Vices
- 3D PRINTING
New products
New products
zł60.18 tax excl.
A board with a built-in ESP-WROOM-32 module and an 0.96 "OLED display (SSD1306) with a resolution of 128x64. The ESP32 system enables communication of WiFi 2.4 GHz and Bluetooth BLE v4.2 networks. modESP32_OLED
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
The board with the built-in ESP-WROOM-32 module and the 0.96 "OLED display (SSD1306) with a resolution of 128x64 pixels The ESP32 system enables communication of 2.4 GHz WiFi networks and Bluetooth BLE v4.2. The system has interfaces: UART, SPI, I2C. The evaluation set can be programmed, among others, in the Arduino environment, in the set with connectors for soldering.
Specification
- The ESP-WROOM-32 system
- Flash memory: 512 kb
- Clock timing: up to 240 MHz
- WiFi standard: 802.11 b / g / n / d / e / i / k / y
- Bandwidth: from 2.412 GHz to 2.484 GHz
- Bluetooth standard: Bluetooth v4.2
- Wi-Fi security: WEP, WPA / WPA2, PSK / Enterprise, AES / SHA2 / Elliptical Curve Cryptography / RSA-4096
- MicroUSB connector for power supply and programming
- 2 buttons: Enable and Boot
- Power supply voltage: from 3.3 V
- Goldpin connectors, 2.54 mm pitch (in the set, solder required)
- Dimensions: 64 x 28 x 8 mm (without connectors)
Included
- IoT Wi-Fi / BT development board with ESP32 chip and 0.96 "OLED display
- Goldpin connector for self-soldering
You might also like
ESP32 is highly-integrated with in-built antenna switches, RF balun, power amplifier, low noise receive amplifier, filters, and power management modules. ESP32 adds priceless functionality and versatility to your applications with minimal Printed Circuit Board (PCB) area requirements. Adafruit 3320
No product available!
Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, Li-Pol battery charging system. Adafruit 3405
Pmod ESP32 is a module with the ESP-WROOM-32 system, allowing for WiFi communication, Bluetooth BLE 4.0 and Bluetooth. For communication, the SPI or UART interface is used (selected by means of the slide switch), which were output on the 12-pin Pmod connector. Digilent 410-377
Development board with an ESP32 module based on a 32-bit Xtens LX6 processor. It has been equipped with a number of peripheral systems such as RGB LED matrix, accelerometer, magnetometer, gyroscope, light sensors and programmable buttons. Banana Pi BPI-Bit
No product available!
Other products in the same category (16)
MCU module combining Wi-Fi and Bluetooth technologies (BR/EDR + BLE). Designed for a wide variety of IoT applications, from sensor networks to more demanding tasks such as voice encoding, music streaming, and MP3 decoding. Espressif ESP32-WROOM-32D 32MBit
Module with WiFi Espressif ESP32-S2. It integrates two 3.3 V stabilizers, SPI Flash memory, LiPo charging circuit, light sensor and RGB diode. It is equipped with a STEMMA QT connector. Adafruit 4769
Module with WiFi and BLE Espressif ESP32-S3. It integrates a LiPo charging circuit and an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5399
Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, Li-Pol battery charging system. Adafruit 3405
The IoT module combining Wi-Fi and Bluetooth (BLE) technologies, which is designed for a wide range of applications, from low-power sensor networks to the most demanding tasks such as voice coding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32D 128MBit
No product available!
The low-power consumption micro-controller intentionally designed for Internet of Things (IoT) projects. The board integrates a Dual-Core ESP-WROOM-32 module, which supports MCU and Wi-Fi &Bluetooth dual-mode communication. DFR0478
Board for applications in the area of the Internet of Things (IoT). The module is based on the ESP-WROOM-32E system with 240 MHz clock, equipped with 4 MB Flash and 520 KB SRAM, as well as WiFi and Bluetooth communication. DFrobot DFR0654-F
No product available!
ESP32-S3 development board equipped with a 32-bit dual-core Xtensa 32-bit LX7 processor. It is equipped with a 1.14-inch IPS LCD display with a resolution of 240 x 135 pixels and a micro SD card slot. It has the format of a USB dongle with a type A connector, which makes it convenient and handy to use. Waveshare ESP32-S3-GEEK
No product available!
Development board designed for IoT projects. It is equipped with a WiFi/Bluetooth module ESP32, LoRa 868 MHz, GPS and a basket for a Li-Ion 18650 battery. TTGO T-Beam V1.1
No product available!
Adapter for ESP8266 modules dedicated to control addressable RGB LEDs from the WS2812 series
Espressif ESP32-C3 WiFi module board. It offers 4 MB of Flash memory and 400 kB of SRAM, as well as an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5700
Development board equipped with ESP32-S3-WROOM-1 module. It is an interesting alternative to Arduino Uno boards. It has a compatible shape and pin layout, while making available the large resources offered by the ESP32 microcontroller. It can be programmed with Arduino, ESP-IDF, MicroPython and CircuitPython. SB Components 26647
A board with an ESP32 module equipped with a 1.28-inch touch screen. It offers Wi-Fi and Bluetooth 5.0 communication and has a built-in 6-axis QMI8658 IMU sensor and supports charging lithium batteries. Perfect for developing IoT, mobile devices and wearable electronics projects. Waveshare ESP32-S3-Touch-LCD-1.28
No product available!
Development board designed for IoT projects. It is equipped with a WiFi/Bluetooth module ESP32, LoRa 433 MHz, GPS and a basket for a Li-Ion 18650 battery. TTGO T-Beam V1.1
No product available!
Board with WiFi and BLE Espressif ESP32-S3 module and OV2640 camera and digital microphone. It offers 8 MB Flash memory and 8 MB SRAM. It is equipped with a USB type C connector and a WiFi/BT antenna. Seeed Studio 113991115
The Espressif ESP32-S3-WROOM-1 WiFi and Bluetooth LE module board offers 8 MB Flash memory and 8 MB PSRAM. The pinouts are compatible with the ESP32-S3-DevKitC-1 modules.Waveshare ESP32-S3-DEV-KIT-N8R8-M