nRF5340-DK - development kit with SoC nRF5340 Bluetooth 5.2

Description

The NRF5340 DK is a development kit with the nRF5340 System-on-Chip (SoC) that supports a wide range of wireless protocols. It supports Bluetooth Low Energy, Bluetooth Mesh, Thread and Zigbee technology (which can run simultaneously with Bluetooth Low Energy) and the NFC, ANT, 802.15.4 and 2.4 GHz protocols. The development kit comes with an NFC antenna that allows you to quickly test the functionality of the nRF5340 NFC-A tag. The board includes a SEGGER J-Link debugger, enabling full programming and debugging of both the nRF5340 SoC and external devices.

All analog and digital interfaces as well as GPIO are accessible via led out connectors. The kit is compatible with the Arduino Uno Rev3, which means that it can be easily connected with shields. The board is equipped with four buttons and four user programmable LEDs and an external memory that is connected to the QSPI interface. The NRF5340 DK can be powered via USB, from an external source, CR2032 battery or Li-Po battery, and the power consumption can be measured using dedicated pins.

The set is programmed using the dedicated nRF Connect SDK tool, which supports the development of Bluetooth Low Energy, Thread and Zigbee application software and integrates Zephyr RTOS.

Features

• nRF5340 SoC
• Efficient Application Processor:
• 128/64 MHz Arm Cortex-M33 with FPU and DSP
• 1 MB Flash + 512 KB RAM
• Fully programmable, ultra-low-power network processor:
• 64 MHz Arm Cortex-M33 with 2 KB of cache
• 256 KB Flash and 64 KB RAM
• Arm TrustZone® and Arm CryptoCell-312
• Bluetooth Low Energy:
• Bluetooth 5.2
• LE Audio
• Search for a direction
• 2 Mb/s, long range
• Bluetooth mesh
• Thread, Zigbee, and 802.15.4
• NFC
• Digital interfaces with EasyDMA:
• QSPI with 96 MHz encryption for external memories
• 32 MHz high speed SPI for displays and sensors
• 4 x UART / SPI / TWI
• 12 Mbps full-speed USB, I²S, PDM, 4 x PWM, 2 x QDEC
• 12 bit, 200 ksps ADC
• Compatible with Arduino Rev3
• 2.4 GHz and NFC antennas
• SWF RF connector for direct RF measurements
• 4p Programmable LEDs and 4 buttons
• Programmer / debugger SEGGER J-Link OB
• Pins for measuring energy consumption
• Programming mass storage devices (MSD) by drag-and-drop
• 1.7 to 5 V power supply from USB, external Li-Po battery or CR2032 coin cell battery

Kit contains

• nRF5340-DK Development Kit
• NFC antenna