DFRobot RP-L-170 Thin Film Pressure Sensor

A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0294

Force-Sensing Resistor - 0.2" Circle

Set with the ADC HX711 transducer module and a pressure sensor in the form of a tensometric beam. It communicates via the UART interface. It allows you to build a simple home scale. DFRobot SEN0160

Flexible pressure sensor with dimensions of 400x15 mm. Designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0299

Aluminum extensometer beam, allowing measurement of weight up to 20 kilograms. It has four wires. It is used in kitchen scales and portable scales, it has a 21 cm cable, RoHS.

M5Stack U177 – Unit Mini Scales is a ready-to-use weighing module based on the HX711 and STM32, featuring I2C communication and support for popular platforms. It is used in laboratory, production and educational projects that require precise mass measurement.

The module allows you to attach a strain gauge (working in the Wheatstone bridge circuit) and convert the analog signal into its digital representation, available on the module output lines. The system processes the signal with a 24-bit resolution and can be powered by 2.7V - 5.5V. The module is especially recommended for constructing digital scales in combination with Arduino

Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0297

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878

Flexiforce Pressure Sensor A201 – 1lb, Tekscan, RoHS

A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0298

Simple-to-use, open source solution for measuring weight and temperature with the ability to read multiple types of load cells and offers a simple-to-use serial menu to configure calibration value, sample rate, time stamp and units of precision. SEN-13261

This disc load cell (sometimes called a strain gauge) can translate up to a whopping 200kg of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that changes in response to, and proportional of, the strain (e.g. pressure or force) applied to the disc. SEN-13332

Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553

Educational module for measuring force in the range from 30 g to 1.5 kg, based on a flexible material that responds with a change in the analog signal. Thanks to its small thickness (0.4 mm), fast response and compatibility with Arduino, micro:bit and Unihiker, it is ideal for teaching physics, engineering and DIY projects. DFRobot SEN0616

M5Stack U180 module with the HX711 chip enables reading data from weight sensors via I2C, providing precise force and mass measurements in projects based on the M5Stack platform. Ideal for compact weighing and dosing systems.