Qwiic Shield Extended - Qwiic extension module for Teensy

Module with digital barometer BMP384. It enables pressure measurement in the range from 300 to 1250 hPa with 24-bit resolution and communicates via I2C or SPI. SparkFun SEN-19662

Qwiic Cable - 500mm

Module with a capacitive touch sensor based on the CAP1203 chip. There are three touch panels on the board that can be used as separate sensors (pins CS1, CS2, CS3) or as a touch slider. I2C communication. SparkFun SEN-15344

Class D stereo sound amplifier based on the Texas Instruments TPA2016D2 circuit. It can work with 4 Ω speakers with power up to 2.8 W or 8 Ω with power up to 1.7 W in stereo mode. SparkFun DEV-20690

LiPo battery monitor module based on the MAX17048 chip. Allows the voltage and state of charge of the battery to be measured. SparkFun SPX-17715

GPS module with GNSS receiver ZED-F9P. It can receive data from GPS, GLONASS, Galileo and BeiDou systems. It has USB, UART, I2C and SPI interfaces. RTK and high accuracy up to 10 mm. SparkFun GPS-16481

ENS160 gas sensor module to measure the concentration of carbon dioxide (eCO2) and volatile organic compounds (TVOC) in the air. It communicates via an I2C or SPI interface. SparkFun SEN-20844

Module with integrated proximity and ambient light sensors and IR emitter in the VCNL4040 system. It allows the detection of obstacles in the range of 0 to 20 cm (no dead zone). It communicates via the I2C bus. SparkFun SEN-15177

End module of the communication system based on QwiicBus. It allows you to extend the range of the I2C bus. SparkFun COM-16988

Air velocity sensor module based on the FS3000-1015 system. The board is equipped with connectors in the Qwiic standard. SparkFun SEN-18768

The Qwiic connector overlay provides an easy-to-install way to add Qwiic connectors to Arduino Nano inserts. Communication takes place via the I2C interface. Sparkfun DEV-16789

Module with an IO pin expander based on the TCA9534 system. It allows you to add 8 GPIO pins to an I2C-controlled project. SparkFun DEV-17047

Mini module with ToF VL53L5CX sensor with a matrix of 64 pixels and a range of up to 4 m. It is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun SEN-19013

Module with the 3-axis MMA8452Q accelerometer. The system has a user selectable measurement scale of ±2g/±4g/±8g. There are two Qwiic connectors on the board and holes with 2.54 mm raster. SparkFun SEN-14587

GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-15712

GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329