.png)
Voltage Regulator module 12V Step-Down 2.4A D36V28F12
ID: 586592
5906623480401
zł92.37
Tax included
zł75.10 tax excl.
Step-Down converter D36V28F12 with an output voltage of 12 V, an input voltage from 12.9 to 50 V and a maximum output current of 3.3 A. Pololu 3786
Description
Step-Down converter module D36V28F12 with an output voltage of 12 V and an input voltage from 12.9 to 50 V. The maximum current load of the module is from 2 to 3.3 A and depends on the input voltage. The inverter achieves a standard efficiency of over 80-90%, which is dependent on the input voltage and load. The module is protected against reverse polarity, overheating, overload and short circuit.
Pinout
- VIN - power input
- GND - ground
- VOUT - output
- PG - an open drain output that goes low when the regulator's output voltage rises more than 20% above or drops by more than 10% below the nominal voltage
- EN - converter is enabled by default (100 kΩ pull-up resistor on the board connects EN pin with VIN). The ENABLE pin can be set low to turn off the power and put the board into a low-power state.
Features
- Input voltage: 12.9 to 50V
- Output voltage: 12V
- Type. maximum current: from 2 to 3.3 A
- Built-in protection against overheating, overload, short circuit and reverse polarity
- Type. efficiency: 80-90%
- Switching frequency: approx. 500 kHz under heavy loads
- Energy saving mode
- Typical quiescent current from 2 mA to 3 mA
- EN input with a precise cut-off threshold to disconnect the load and put the controller into a low-power state
- Power good output, which indicates when the controller cannot maintain the output voltage adequately
- The soft-start function limits the inrush current and gradually increases the output voltage
- Two M2 mounting holes
- Dimensions: 17.8 x 20.3 x 8.8 mm
Parameters
Kit contains
- D36V28F12 converter module
- Straight 6-pin goldpin connector
- 5-pin angled goldpin connector
586592
Data sheet
- Output voltage
- 12V
- Output current
- 2.4A
- Converter type
- Step-down
- Supply voltage min
- 12,9 V
- Supply voltages max
- 50 V
Manufacturer
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
Responsible person
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
You might also like
The Step-Up Buck Voltage Regulator module with adjustable output voltage in range of 4-25V with a input voltage range of 1.5-16V and a maximum output current of 2A. Pololu 799
zł88.31
24h
Available quantity: 1
Available
Step-Up converter U3V70A with an output voltage from 4.5 to 20 V, an input voltage from 2.9 to VOUT and a maximum output current of 10 A. Pololu 2890
zł116.24
Delivery date unknown
No product available!
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output on a 5.08 mm ARK screw connector. Allows you to power devices with 5 V, 9 V, 12 V, 15 V and 20 V and test chargers by replacing the PD device
zł27.05
24h
Available quantity: 18
Available
A set of 40 pieces of female-female connecting cables in various colors, 10 cm long
zł4.90
24h
Available quantity: 209
Available
A set of 40 pcs of male-female connecting cables in various colors, 10 cm long
zł4.48
24h
Available quantity: 396
Available
A set of 40 pcs of male-male connecting cables in various colors, 10 cm long
zł5.10
24h
Available quantity: 488
Available
Step-Down converter D36V50F12 with an output voltage of 12 V, an input voltage from 13.3 to 50 V and a maximum output current of 6.5 A. Pololu 4095
zł180.71
24h
Available quantity: 2
Available
Other products in the same category (16)
DC-DC step-down converter module 12V 12A used to convert energy from 15-24V input voltage to stable 12V, providing up to 12A current. Thanks to high conversion efficiency (over 90%) and low ripple (<50mV), it is ideal for powering sensitive devices in applications such as robotics, drones or LED lighting systems. Additionally, built-in overheating and short-circuit protection mechanisms ensure reliable operation even in difficult conditions. DFRobot DFR1208
zł68.90
24h
Available quantity: 3
Available
DC-DC step-down converter module 5V 16A used to convert energy from 6-24V input voltage to stable 5V, providing up to 16A current. Thanks to high conversion efficiency (over 90%) and low ripple (<20mV), it is ideal for powering sensitive devices in applications such as robotics, drones or LED lighting systems. Additionally, built-in overheating and short-circuit protection mechanisms ensure reliable operation even in difficult conditions. DFRobot DFR1202
zł57.76
24h
Available quantity: 2
Available
The DC-DC Buck Converter DC5-36-TO-DC3V3-5 in SMD version is designed for direct surface mounting. With selectable output voltage and high efficiency, it is suitable for applications involving microcontrollers, IoT systems, and mobile electronic devices.
zł14.06
24h
Available quantity: 14
Available
DC-DC Buck Converter 5–36 V with 5 V or 3.3 V output in the DC5-36-TO-DC3V3-5-M version is equipped with terminal and pin headers for quick deployment in power applications. High efficiency, adjustable voltage, and compact size make it suitable for powering microcontrollers, communication modules, and embedded systems.
zł16.20
24h
Available quantity: 10
Available
Miniature 15 V switching voltage regulator based on the AP63200 IC, input range 3.5 - 32 V, output current up to 1 A (1.5 A peak), efficiency up to 90%, dimensions 18 x 11 mm. KAmod-DCDC-AP63200 15V
zł15.99
24h
Available quantity: 40
Available
Miniature Step-Down converter module with AP63300, input voltage 3.5-32 V, selectable output voltage 3.3 V, 5 V or 12 V, maximum continuous current 1 A, peak current up to 2 A, dimensions 24 x 16 mm. Kamami KAmod DCDC AP63300
zł18.91
24h
Available quantity: 212
Available
Step-down voltage regulator module based on the APM81815 providing a fixed 3.3 V output at up to 1.1 A with an input voltage range of 5 - 72 V. Pololu 5266
zł25.02
6 weeks
No product available!
Step-down voltage regulator module based on the APM81815 providing a fixed 5 V output at up to 1.1 A with an input voltage range of 5.05 - 72 V. Pololu 5267
zł25.89
6 weeks
No product available!
Step-down voltage regulator module based on the APM81815 providing a fixed 5.35 V output at up to 1.1 A with an input voltage range of 5.4 - 72 V. Pololu 5268
zł25.02
6 weeks
No product available!
Step-down voltage regulator module based on the APM81815 providing a fixed 12 V output at up to 0.8 A with an input voltage range of 12.1 - 72 V. Pololu 5269
zł27.15
24h
Available quantity: 4
Available
Miniature 2.5 V switching voltage regulator based on the AP63200 converter, input range 3.5 – 32 V, output current up to 1 A (1.5 A peak), efficiency up to 90%, dimensions 18 x 11 mm. KAmod-DCDC-AP63200 2.5V
zł15.99
24h
Available quantity: 20
Available
Miniature 3.3 V switching voltage regulator based on the AP63200 converter, input range 3.5 – 32 V, output current up to 1 A (1.5 A peak), efficiency up to 90%, dimensions 18 x 11 mm. KAmod-DCDC-AP63200 3.3V
zł15.99
Delivery date unknown
No product available!
Miniature 4.2 V switching voltage regulator based on the AP63200 IC, input range 3.5 – 32 V, output current up to 1 A (1.5 A peak), efficiency up to 90%, dimensions 18 x 11 mm. KAmod-DCDC-AP63200 4.2V
zł15.99
24h
Available quantity: 19
Available
Miniature 5 V switching voltage regulator based on the AP63200 IC, input range 3.5 – 32 V, output current up to 1 A (1.5 A peak), efficiency up to 90%, dimensions 18 x 11 mm. KAmod-DCDC-AP63200 5V
zł15.99
Delivery date unknown
No product available!
Miniature 8.4 V switching voltage regulator based on the AP63200 IC, input range 3.5 - 32 V, output current up to 1 A (1.5 A peak), efficiency up to 90%, dimensions 18 x 11 mm. KAmod-DCDC-AP63200 8,4V
zł15.99
24h
Available quantity: 13
Available
Miniature 12 V switching voltage regulator based on the AP63200 IC, input range 3.5 - 32 V, output current up to 1 A (1.5 A peak), efficiency up to 90%, dimensions 18 x 11 mm. KAmod-DCDC-AP63200 12V
zł15.99
24h
Available quantity: 11
Available
Step-Down converter D36V28F12 with an output voltage of 12 V, an input voltage from 12.9 to 50 V and a maximum output current of 3.3 A. Pololu 3786