Products
Categories
- Main categories
-
- 3D PRINTING
- ACADEMIC OFFER
- ARDUINO
- AUTOMATION
- BOOKS
- DIY KITS
- AVT kits
- Audio
- Car
- Chargers
- Clocks, timers and schedule switches
- Communication
- Converters
- Development kits and modules
- Displays
- Electronic games
- Generators
- Hobbies and fun
- House
- Interfaces
- Light effects
- meters
- PC
- Power Supplies
- Pre-programmed circuits
- Printed circuit boards (PCB)
- Programmers
- Regulators, controllers
- Remote control
- Starter sets Ośla Łączka
- Starting sets for beginners
- Workshop tools
- Audio
- Other sets
- TOP-Q kits
- Totem
- UGears
- Velleman
- AVT kits
- EBOOKS
- ELECTRONICS
- Cables
- Cameras and accessories
- Communication
- Conductive materials
- Connectors
- ARK connectors (Terminal Block)
- Coaxial connectors (RF)
- Connectors
- Crocodile clip
- D-Sub drawer connectors
- DC power connectors
- FFC/FPC ZIF connectors
- Goldpin connectors
- IDC connectors
- JACK connectors
- JST connectors
- Jumpers
- Memory cards slots
- Other connectors
- Pogo pin
- RJ45 sockets
- Slip ring connector
- Supports
- Szybkozłącza
- USB connectors
- Cooling
- Displays
- Electronic modules
- A/D and D/A converters
- Audio
- Barcode readers
- CAN converters
- Converters USB - UART / RS232
- Data logger
- DDS/PLL generators
- Digital potentiometers
- Encoders
- Expanders of the I/O
- Fingerprint readers
- HMI modules
- Image and video
- JTAG accessories
- Keyboards, buttons
- LED drivers
- Memory card readers
- Memory modules
- Modules with power outputs
- Motor controllers
- Power modules
- RS485 converters
- RTC modules
- Servo Controllers
- TSOP infrared receivers
- USB Converters - I2C / 1-Wire / SPI
- Voltage converters
- Gadgets
- GPS
- Intelligent clothes
- LED - diodes, displays, stripes
- Luminous wires and accessories
- Memory cards and other data storages
- Passive elements
- PC accessories
- Printers
- Prototype boards
- Semiconductors
- A/C converters (ADC)
- Analog systems
- Audio systems
- Bridge rectifiers
- Button
- D/A Converters (DAC)
- DDS synthesizers
- Digital circuits
- Diodes
- Drivers of motors
- DSP microprocessors
- Energy counters
- Energy harvesting
- ESD security
- IGBT drivers and bridges
- Interface systems
- LED drivers
- Logic converters
- Memory
- Microcontrollers
- Optotriacs and optocouplers
- Other
- PLL generators
- Power systems
- Programmable systems
- Resetting systems
- RF systems
- RTC systems
- Sensors
- SoC systems
- Timery
- Touch sensors
- Transistors
- Sensors
- Accelerometers
- Air humidity sensors
- Air quality sensors
- Current sensors
- Distance sensors
- Flow sensors
- Gas sensors
- Gyroscopes
- Hall sensors
- Humidity sensors
- Infrared sensors
- Light and color sensors
- Liquid level sensors
- Magnetic sensors (compasses)
- Medical sensors
- Motion sensors
- PH sensors
- Position sensors
- Pressure sensors
- Pressure sensors
- Reflection sensors
- Sensors 6DOF/9DOF/10DOF
- Sensors of liquid quality
- Temperature sensors
- Vibration sensors
- Sound transducers
- Switches and buttons
- Cables
- INTERNET OF THINGS (IoT)
- MECHANICS
- POWER
- R/C MODELLING
- RASPBERRY PI
- Accessories for Raspberry Pi
- Audio video cables for Raspberry Pi
- Case Raspberry Pi
- Cooling for Raspberry Pi
- Displays for Raspberry Pi
- Extension modules for Raspberry Pi
- Memory cards for Raspberry Pi
- Power for Raspberry Pi
- Raspberry Pi 3 model A+
- Raspberry Pi 3 model B
- Raspberry Pi 3 model B+
- Raspberry Pi 4 model B
- Raspberry Pi 400
- Raspberry Pi 5
- Raspberry Pi cameras
- Raspberry Pi Compute Module
- Raspberry Pi model A/ B+/2
- Raspberry Pi Pico
- Raspberry Pi prototyping
- Raspberry Pi Zero
- Raspberry Pi Zero 2 W
- RETIRED PRODUCTS
- ROBOTICS
- SALE
- SOFTWARE
- STARTER KITS, PROGRAMMERS, MODULES
- Alchitry FPGA
- Altera FPGA
- Analog electronics
- Atmel SAM
- Atmel Xplain
- AVR
- Banana Pi
- BeagleBone
- chipKIT
- Coral
- CPLD Xilinx
- Cubieboard
- DFRobot FireBeetle
- Feather
- Freedom (Kinetis)
- FriendlyELEC
- HummingBoard
- Intelligent clothes
- Kit with a book
- LattePanda
- LPC (NXP)
- M5Stack
- Micro:bit
- Nvidia Jetson
- Odroid
- ODYSSEY
- Orange Pi
- Other development kits
- Peripheral modules
- PIC
- Raisonance
- Raspberry Pi RP2040
- RFID
- RISC-V
- SBC Embest
- SBC MYIR
- SBC others
- SBC UDOO
- Segger programmers
- SoMLabs
- Sparkfun MicroMod
- STM32
- STM32 Discovery
- STM32 MP1
- STM32 Nucleo boards
- STM8
- Teensy
- Universal programmers
- WRTNode
- Xilinx FPGAs
- WORKSHOP
- Adhesives and gluers
- Anti-static mats (ESD)
- Chemistry
- CNC milling machines
- Crimping tools
- Dispensing needles
- Drills
- Files
- Generators
- Handles, magnifiers
- Heat-shrink tubing
- Insulation strippers
- Keys
- Knives and scissors
- Laboratory power supplies
- Laminates
- Measuring devices
- Mikroskopy
- Mini drills and grindrers
- Organizers
- Oscilloscopes and accessories
- Pliers and pincers
- Riveting tools and rivets
- Screwdrivers
- SMD Accessories
- Soldering
- Tapes (aluminum, kapton, copper, insulating)
- Tweezers
- Ultrasonic cleaners
- Vices
- 3D PRINTING
New products
New products
zł1,768.94 tax excl.
A programming platform designed on the basis of the Xilinx system-on-chip system Zynq-7000 (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz processor with the Xilinx 7 FPGA chip. Digilent Cora Z7-10 (410-370-1)
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
Cora Z7 from Digilent is a cheap and easy-to-use programming platform designed on the basis of Xilinx's Zynq-7000 System-on-Chip system (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz dual core processor with the Xilinx 7 FPGA chip. This provides the ability to surround the processor with a unique set of software peripherals and controllers tailored to the target application.
The wide range of Cora Z7 hardware interfaces, from Ethernet PHY 1 Gb / s converters to analog-digital converters and general purpose input / output pins makes it an ideal platform for developing a wide range of embedded applications. The small housing and mounting holes make the Cora Z7 ready for use as part of a larger solution. Thanks to the built-in SD, Ethernet and Power card slot, the Cora Z7 solution can operate independently of the host computer.
properties
- ZYNQ processor
- Dual-core 667 MHz Cortex-A9 processor
- Programmable FPGA logic corresponding to Artix-7 FPGA
- 4400 programmable logical clusters
- 80 DSP clusters
- 270 KB block RAM
- DDR3 memory controller with 8 DMA channels and 4 high-performance AXI3 slaves
- Broadband peripheral controllers: 1G Ethernet, USB 2.0, and SDIO
- Low-band peripheral controllers: SPI, UART, CAN, I2C
- Two-channel, 1 internal analogue-digital MSPS converter
- Programmable with JTAG and microSD card
- Memory
- 512 MB of DDR3 memory with a 16-bit bus at 1050 Mb / s
- microSD slot
- Powered by USB or any external 4.5 ... 5.5V power source
- USB and Ethernet
- Gigabit Ethernet PHY with a 48-bit globally unique identifier compatible with EUI-48/64 available on the sticker
- USB-JTAG programming circuits
- USB-UART bridge
- USB OTG PHY (only supports host)
- Two buttons
- Two RGB LEDs
- Expansion connectors
- Two Pmod connectors - 16 All I / O FPGAs
- Arduino / chipKIT Shield connector
- Up to 49 digital inputs / outputs FPGA
- 6 analog inputs 0 ... 3.3V to XADC
- 8 differential 0 ... 1,0V analog inputs to XADC
- 12 additional digital FPGA inputs / outputs
Description of the system's I / O
Number | Description | Number | Description |
---|---|---|---|
1 | Power selection jumper (external / USB) | 11 | MicroSD socket |
2 | Power connector | 12 | USB host port |
3 | USB JTAG / UART port | 13 | FPGA LED |
4 | Extension connector | 14 | CPU reset button |
5 | Pmod connector | 15 | Ethernet port |
6 | SPI (Arduino / ChipKIT) | 16 | POWER ON button |
7 | Arduino / ChipKIT connector | 17 | Power LED |
8 | Jumper of programming mode (JTAG / microSD) | 18 | Zynq-7000 |
9 | User's LED | 19 | DDR3L memory |
10 | User button |
You might also like
Arty is a ready-to-use development platform designed around the Artix-7™ Field Programmable Gate Array (FPGA) from Xilinx. 410-319
No product available!
Ready-to-use development platform designed around the Zynq-7000 All Programmable System-on-Chip (AP SoC) from Xilinx. The Zynq-7000 architecture tightly integrates a dual-core, 650 MHz ARM Cortex-A9 processor with Xilinx 7-series Field Programmable Gate Array (FPGA) logic. Digilent 410-346-20
No product available!
Arty S7-50 is a development kit with Xilinix FPGA XC7S50-CSGA324. The board has many peripherals: slide switches, monostable buttons, RGB LEDs etc. Digilent (410-352)
Arty S7-25 is a development kit with Xilinx FPGA XC7S25-CSGA324. The board has many peripherals: slide switches, monostable buttons, RGB LEDs etc. Digilent (410-352)
No product available!
A programming platform designed on the basis of the Xilinx system-on-chip system Zynq-7000 (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz processor with the Xilinx 7 FPGA chip. Digilent Cora Z7-07S (410-370)
Other products in the same category (16)
No product available!
No product available!
Development kit with Xilinx Spartan-6 FPGA with built-in DDR memory and IO interface expansion connectors. The base board facilitates access to the FPGA IO. Numato Lab FPGA005
No product available!
No product available!
Image processing kit on the ZedBoard development board. The kit includes a Zedboard board, an adapter and four Pcam cameras. Digilent 471-034-1
No product available!
No product available!
FPGA development board with Xilinx Artix-7 FPGA. Equipped with PCIe interface, Trusted Platform module, Dual SFP and 2 GB of DDR3 SDRAM memory. Numato Lab NLFX1005
No product available!
Development board FPGA with ZYNQ XC7Z020-1CLG400C system, built-in USB, audio / video interfaces, JTAG programmer and compatible connector Arduino UNO R3 and Raspberry Pi. The set works with the open-source PYNQ project that combines FPGA with Python. TUL PYNQ-Z2
Eclypse Z7 evaluation kit (ARM Cortex-A9 + FPGA Artix-7) with two converter Zmod DAC 1411 plugged into the SYZYGY interface connector. Digilent 471-036-2
No product available!
ZedBoard is a low-cost development board for the Xilinx Zynq-7000 all programmable SoC (AP SoC). This board contains everything necessary to create a Linux®, Android®, Windows®, or other OS/RTOS based design. 410-248
Module with Xilinx Artix-7 100T system, FLASH memory with 32 MB capacity, 1 GB RAM memory and 10/100 Mbit Ethernet controller. Everything fits on a small 4 x 5 cm tile. TE0712-01-100-2C
No product available!
No product available!
Base plate for Trenz Electronics 4x5 cm modules, e.g. TE0741, TE0712. The board allows connecting to the module interfaces: USB, Ethernet, JTAG. TE0705-04
No product available!
Module with Xilinx Artix-7 200T system, FLASH memory with 32 MB capacity, 1 GB RAM memory and 10/100 Mbit Ethernet controller. Everything fits on a small 4 x 5 cm tile. TE0712-02-200-2C
No product available!
FPGA development board with Xilinx Spartan-6 FPGA. Designed for a wide variety of applications. Numato Lab FPGA008A-SS
No product available!
FPGA development board with Kintex 7 FPGA system and FT2232H two-channel USB converter from FTDI. Numato Lab FPGA010A-SS
No product available!