Category: STARTER KITS, PROGRAMMERS, MODULES

Module with laser distance sensor ToF VL53L0X designed for M5Stack sets. It can detect simple hand gestures. M5Stack U010

Module with a 10 kΩ rotary potentiometer for M5Stack sets. M5Stack U005

Module with a PIR motion sensor designed for M5Stack modules. It can detect movement up to 5 meters with a detection angle of 100 degrees. M5Stack U004

WiFi wireless communication module compatible with the pin spacing of XBEE modules. The module is powered by 3.3 V. The product is compatible with Arduino. DFRobot TEL0092

Voltmeter module for M5Stack sets. It can measure DC voltage in the range from 0 to 36 V with an accuracy of approx. 0.5 mV. M5Stack U087

A module that allows you to create your own layout based on the Feather tile. Equipped with prototype holes and a set of screw connectors with pins out. Adafruit 2926

Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029

Adafruit Feather M0 WiFi - ATSAMD21 + ATWINC1500 is a development board with a 32-bit ATSAMD21G18 microcontroller based on Cortex-M0 core. The board also has an ATWINC1500 module that provides WiFi connectivity. Adafruit 3010

Ammeter module designed for M5Stack sets. It can measure direct current in the range from 0 to 4 A with a resolution of approx. 0.15 mA. M5Stack U086

Kit for building a worm robot. The chassis is equipped with four motors and a controller, 2 RGB diodes and an STM32F030 microcontroller. M5Stack K033

A set for building a walking robot. The chassis is equipped with four servos, a controller and an STM32F030 microcontroller. M5Stack U086

Extension board designed for MicroMod processor modules. All the pins are led out to connectors with a pitch of 2.54 mm. SparkFun DEV-16885

ESP32-S3-DevKitC-1U-N8R8 board with Wi-Fi, BLE, 8 MB flash, and 8 MB PSRAM for IoT projects and AI applications. Espressif ESP32-S3-DevKitC-1U-N8R8

The STM32 Nucleo-64 boards provide an affordable and flexible way for users to try out new concepts and build prototypes with the STM32 microcontrollers, choosing from various combinations of performance, power consumption and features

A module dedicated to power analysis of nRF5 series development boards. It is designed to measure and optimize power consumption in embedded device applications. Nordic Semiconductor nRF6707

Gravity Colorful LED is an LED twinkles with seven colors--the colors of rainbow. DFRobot DFR0474

LM386 audio amplifier module in a set with a loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 101020853

Power supply module with a 650 mAh battery for the Wio Terminal set. Seeed Studio 103990564

Wio development kit equipped with LTE 4G communication and a GNSS satellite navigation module. Seeed Studio 102991022

Module with a GPS receiver based on the MTK3333 system. Dedicated to Feather plates, communicates via the UART interface. Adafruit 3133