Category: STARTER KITS, PROGRAMMERS, MODULES

Module with a button and red LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-R

8 MB PSRAM memory chip, designed for mounting on Teensy 4.1 boards. It enables the expansion of the memory of the microcontroller. PJRC IC-PSRAM-8MB-SOIC8

NFC module with built-in antenna on the board. The module has a Gravity connector. Memory communication can be done through one of the serial interfaces: UART or I2C. DFRobot DFR0231-H

Expansion board compatible with STM32 Nucleo. Allows you to prototype solutions with digital microphones. STMicroelectronics X-NUCLEO-CCA02M2

STM32 Nucleo-144 development board with STM32F722ZE MCU, supports Arduino, ST Zio and morpho connectivity

Adapter for WS2811 LED strips designed for Teensy 3.2, 3.5, 3.6 and 4.1. It uses the 74HCT245 chip and RJ45 connectors for communication with RGB LED strips. Teensy 3.2-4.1 PJRC OCTO28-ADAPTOR

Module with red LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030005

Connectivity expansion board based on the STM32WL5MOC module, intended for prototyping and testing LPWAN applications in the sub-GHz band. Supports LoRa and (G)FSK, (G)MSK, and BPSK modulations, and integrates MEMS sensors with broad expansion capabilities. STMicroelectronics B-WL5M-SUBG1

Multifunctional micro:bit expansion module with built-in Li-Ion battery. The board is equipped with a two-channel DC motor driver, 9 IO pins, I2C, UART interface, buzzer, 4 RGB LEDs and a charging circuit. DFRobot MBT0005

Module with tact switch button. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020003

WiFi module with ESP8266 designed to work with the Raspberry Pi Pico. It communicates via the UART interface using AT commands. Waveshare Pico-ESP8266

Module with white LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030009

Module with WiFi Espressif ESP32-S2 WROOM. It integrates a set of peripheral devices - capacitive touch sensors, SPI, UART, I2S and I2C. SparkFun WRL-15663

Waterproof soil moisture sensor with analog output. The probe has a pointed tip, which allows it to be easily inserted into the ground. It is supplied with the voltage from 3.3V to 5.5V. DFRobot SEN0308

Fan module with DC motor, propeller and connection cable. DFRobot DFR0332

Module with 5 A 250 VAC relay. DFRobot DFR0017

Module with a button, LED diode and a blue cap. DFRobot DFR0029-B

MCIMX6ULL-EVK is an evaluation set from NXT with i.MX6ULL ARM Cortex-A7 900 MHz processor, 4 GB SDRAM memory and USB Host and OTG connector, Ethernet interface and SD card slot. MCIMX6ULL-EVK

Module with liquid turbidity sensor. The board is equipped with a Grove connector and communicates via a digital or analog interface. Seeed Studio 101020752

Module with a TDS sensor that allows you to measure the total content of solids dissolved in water. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020753