Category: Electronic modules

3-channel brush motor controller module with PWM signal mixing function. It allows you to control three DC motors with a current consumption of up to 3 A per channel

Universal tester of servos and ESC regulators. It allows you to check the operation of the servo without the need for a transmitter and receiver

The CAN transmitter and receiver module is intended for M5Stack sets. It is based on an isolated CA-IS3050G transceiver system, which can provide differential data reception and transmission. M5Stack U085

The module is equipped with two buttons in red and blue. It communicates via a digital interface and allows you to add simple controls to your M5Stack based project. M5Stack U025

Module with a precise real time clock (RTC) DS3231. It has an integrated crystal resonator and communicates via the I2C interface. Adafruit 5188

MEMS SPU0414HR5H-SB analog microphone module. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020852

The board generates 16 PWM signals and communicates using the digital I2C interface, it has a built-in PCA9685 chip. MOD 71

The X-NUCLEO-IHM16M1 motor driver expansion board is based on the STSPIN830 monolithic driver for three-phase brushless motors. It represents an affordable, easy-to-use solution for driving brushless motors in your STM32 Nucleo project, implementing single and three-shunt current sensing

This small synchronous switching step-down (or buck) regulator takes an input voltage from 4 V to 36 V and efficiently reduces it to 3.3 V. The board measures only 0.7″ × 0.7″ yet delivers a typical continuous output current of up to 2.6 A and features reverse voltage protection.

A small module with a PIR motion sensor. It allows detecting movement within a maximum range of 6 meters (default up to 3 meters). The measuring angle is 120 degrees. The module has a connector in accordance with the Grove standard. Seeed Studio 101020020

The module with the tilt sensor, the sensor output is a digital signal. The module has a connector in accordance with the Grove standard. Seeed studio 101020025

The board based on the L298 Dual Full-Bridge Motor Driver; can provide up to 4 Amps of current to the motors (2 Amps per motor). ROB-09571

Fire Fighting Light Detection Flame Sensor Module, RoHS

DC-DC Step-up converter module based on the U3V70F5 system. Input voltage 2.9 ... 5V, output voltage 5V, maximum current 10A. Two mounting holes. Polol 2891

(DRI0009) 2A Motor Shield For Arduino

The kit includes a control module (with ETA1617 and NE555) and an ultrasonic transducer. The water atomiser module allows for the construction of, for example, a small humidifier. The module has a connector in accordance with the Grove standard. Seeed studio 101020090

The compact (0.4″ × 0.5″) D24V5F5 synchronous buck voltage regulator takes an input voltage of up to 36 V and efficiently reduces it to 5 V while allowing for a maximum output current of 500 mA. Pololu 2843

Gravity: Analog TDS Sensor / Meter is an analog water purity measurement module. It is powered by 3.3 ... 5.5V voltage and has an analogue output interface. Module compatible with Arduino. DFRobot SEN0244

QTR-1A Reflectance Sensor (2-Pack)

Monochrome camera module 10 Mpx with sensor MT9J001 / MT9J003 designed for use with the ArduCam USB Shield module. Lens LS-18023M12. Support for video recording 1080p @ 30fps and VGA @ 60fps. Arducam 10MP: MT9J001 / MT9J003