Category: Audio
Subcategories
There are 276 products.
Module with WM8960 audio decoder that allows you to operate 1 W stereo speakers and two microphones via the I2S interface. Adafruit 4757
Audio module with two microphones and display designed to work with the Raspberry Pi. Pimoroni PIM524
Audio preamplifier based on NE5532 chips. Equipped with an input selector function. Display and remote control included
A module with an electret microphone, amplifier and ADC converter dedicated to micro: bit. It communicates via the I2C interface. SparkFun SEN-15289
A sound card in the form of a small device with a USB plug, designed to work with the Raspberry Pi and NVIDIA Jetson Nano minicomputer. Waveshare USB TO AUDIO
Audio receiver with Bluetooth 4.2 module. It is powered by a microUSB connector and is equipped with 5 control buttons
Gravity: Analog Sound Sensor is a sound sensor with Gravity analogue output. The module can be supplied with 3.3 ... 5V voltage. DFRobot DFR0034
MP3 panel for installation in the audio device. It allows you to play files in MP3 format from a USB memory or a microSD card. It has a built-in 3.5mm Jack connector with an audio output
Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029
A set with a vibration generator designed to transfer sounds through the human skeleton to the auditory center. DFRobot KIT0126
Module with LM386 audio amplifier and loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020001
A volume sensor designed to detect loud ambient sounds. The module uses a microphone and LM2904 amplifier. The output value (analog signal) depends on the volume of the detected sound. In order to eliminate interference, the microphone signal is subjected to double filtering. Seeed studio 101020063
The module is based on the Si4703 FM tuner system. Supports wave reception in a wide frequency range from 76 to 108 MHz. It allows you to read RDS information. SparkFun BOB-11083
This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381
Audio player with HiFi amplifier in aluminum housing. It allows you to play files from USB memory, SD card, via the audio connector and Bluetooth. It has a built-in FM receiver
2-channel stereo audio mixer module. It has four outputs, on which the summed signal from 2 inputs is available. It is powered with the voltage from 5 to 19 V