Tic T500 USB - stepper motor driver
search
  • Tic T500 USB - stepper motor driver
  • Tic T500 USB - stepper motor driver - top view
  • Tic T500 USB - stepper motor driver - bottom view
  • Tic T500 USB - stepper motor driver - dimensions
ID: 570118
5906623478569
zł221.22
Tax included

zł179.85 tax excl.

Tic T500 USB is a stepper motor driver based on the MP6500 chip. It allows you to control the stepper motor whose voltage on the coil is 4.5-35V, the maximum current per coil is up to 1.5A. The controller can be controlled by: USB, TTL, I2C, RC (PWM model) etc. Pololu 3134

24h
Available
Available quantity: 2
Kamami is the official distributor of electronic modules and Pololu robotic parts. All products of this brand in our offer are original and come directly from the manufacturer.
 

Free shipping

free shipping in Poland for all orders over 500 PLN

 

Same day shipping

If your payment will be credited to our account by 11:00

 

14 days for return

Each consumer can return the purchased goods within 14 days

Description

Stepper motor driver based on the MP6500 system. It allows you to control a stepper motor whose voltage per coil is 4.5-35 V, while the maximum current per coil is up to 1.5 A (2.5 A with the use of an additional heat sink for cooling). The controller can be controlled by: USB, TTL, I2C, RC (PWM model), analog input or quadrature encoder. It is also possible to control through the STEP and DIR inputs. Providing a high state on the STEP pin will cause the motor to rotate one step, the motor shaft rotation direction selection is made by providing the appropriate status on the DIR pin. The module has protection against reverse power connection. If the module is supplied with voltage from the range of 4.5-5.5 V, the logic levels will be lower than normal which may affect the operation of the module. More information in the usage guide

properties

  • Stepper motor driver based on the MP6500 system
    • Engine power supply: 4.5-35 V
    • Maximum continuous current: 1.5 A (per channel without using a heat sink)
    • Maximum instantaneous current: 2.5 A (per channel using a heat sink)
    • The microchips can be set: whole, 1/2, 1/4 or 1/8
  • Possibility of control through:
    • USB
    • TTL
    • I2C
    • RC (PWM model)
    • analog input
    • quadrature encoder
    • STEP / DIR
  • Protection against reverse connection of power supply
  • Dimensions: 38 x 27 x 11 mm (without soldered connectors)
  • Weight: 8.2 g

Included

  • Module Tic T500 USB Multi-Interface Stepper Motor Controller
570118

Data sheet

Output current
1,5 A
Number of channels
2
Supply voltage min
4,5 V
Supply voltages max
35 V

You might also like

Other products in the same category (16)