

A GNSS (Global Navigation Satellite System) receiver, which makes it possible to receive navigation signals from satellite navigation systems such as GPS (Global Positioning System) and BeiDou. With this receiver, accurate positioning and real-time navigation is possible. It has two communication interfaces available, including I2C and UART, which allow data to be transferred from the receiver to other devices. This allows the receiver to be integrated into other systems, such as microcontrollers or minicomputers.
The module offers positioning accuracy of up to 2 m. The first positioning time needed to establish position after power-up or restart is approximately 30 seconds. However, for a hot start, i.e. when the receiver has recently been used and already has partial satellite data, it is only 2 s. An antenna with an IPEX1 connector is included with the receiver. This allows the antenna to be easily connected to the GNSS receiver and ensures reliable signal transmission.
GNSS receivers are widely used in car navigation, vehicle tracking systems, marine navigation systems, geodesy, geolocation and many other fields where precise positioning and navigation are crucial. Full module documentation and sample programs are available on the product page.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
Wio development kit equipped with LTE 4G communication and a GNSS satellite navigation module. Seeed Studio 102991022
GPS module with LC29H GNSS receiver designed to work with the Raspberry Pi minicomputer. It allows you to receive data from major positioning systems, including GPS, QZSS, GLONASS, Galileo and BeiDou, and supports fast, dual-band RTK positioning. Waveshare LC29H(DA) GPS/RTK HAT
No product available!
Expansion board with LoRa Node SX1262 module and GNSS L76K dedicated for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 868 MHz frequency band and enables positioning within the GPS, GLONASS, BDS and QZSS systems. Waveshare SX1262 868/915M LoRaWAN/GNSS HAT
KAmodRPi-GPRS-GPS is an overlay for Raspberry Pi 4 / 3B + / 3B / 2B / B + computers, which allows you to enrich the system with the ability to send data via GPRS, SMS transmission or work as a module for Bluetooth communication. This extension also offers the ability to receive satellite data from location systems - GPS and GLONASS.
No product available!
66 channel GPS receiver module LS20031. It communicates via the UART TTL interface with a refresh rate of up to 10 Hz. Pololu 2138
GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-15712
GPS module with GNSS receiver ZED-F9P. It can receive data from GPS, GLONASS, Galileo and BeiDou systems. It has USB, UART, I2C and SPI interfaces. RTK and high accuracy up to 10 mm. Waveshare ZED-F9P GPS-RTK HAT
No product available!
LC76G GNSS receiver module. It can receive data from GPS, GLONASS, Galileo, BDS and QZSS systems. It uses a UART or I2C interface and offers an accuracy of up to 1.5m. Waveshare LC76G GNSS Module
Module with a GPS receiver based on the MTK3333 chip. It is equipped with a STEMMA QT connector and communicates via the UART or I2C interface. Adafruit 4415
GPS module with 72-channel GNSS ZOE-M8Q receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART and I2C interfaces. SparkFun GPS-15193
GPS module with GNSS receiver ZED-F9P. It can receive data from GPS, GLONASS, Galileo and BeiDou systems. It has USB, UART, I2C and SPI interfaces. RTK and high accuracy up to 10 mm. SparkFun GPS-15136
No product available!
Kit with GNSS RTK Express Plus receiver, L1/L2 antenna and accessories. It allows you to get centimeter-level global positioning measurements using GNSS RTK. SparkFun GPS-18589
No product available!
The GPS module allows you to download the current coordinates of position and time, has a built-in GPS receiver FGPMMOPA6H. MOD-54
Function module designed for MicroMod boards. Equipped with the ZED-F9P GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It communicates via UART, I2C and SPI interfaces. SparkFun GPS-18378
No product available!
GNSS receiver to receive navigation signals from satellite navigation systems such as GPS and BeiDou. It offers positioning accuracy of up to 2 m. DFRobot TEL0157