Products
Categories
- Main categories
-
- 3D PRINTING
- ACADEMIC OFFER
- ARDUINO
- AUTOMATION
- BOOKS
- DIY KITS
- AVT kits
- Audio
- Car
- Chargers
- Clocks, timers and schedule switches
- Communication
- Converters
- Development kits and modules
- Displays
- Electronic games
- Generators
- Hobbies and fun
- House
- Interfaces
- Light effects
- meters
- PC
- Power Supplies
- Pre-programmed circuits
- Printed circuit boards (PCB)
- Programmers
- Regulators, controllers
- Remote control
- Starter sets Ośla Łączka
- Starting sets for beginners
- Workshop tools
- Audio
- Other sets
- TOP-Q kits
- Totem
- UGears
- Velleman
- AVT kits
- EBOOKS
- ELECTRONICS
- Cables
- Cameras and accessories
- Communication
- Conductive materials
- Connectors
- ARK connectors (Terminal Block)
- Coaxial connectors (RF)
- Connectors
- Crocodile clip
- D-Sub drawer connectors
- DC power connectors
- FFC/FPC ZIF connectors
- Goldpin connectors
- IDC connectors
- JACK connectors
- JST connectors
- Jumpers
- Memory cards slots
- Other connectors
- Pogo pin
- RJ45 sockets
- Slip ring connector
- Supports
- Szybkozłącza
- USB connectors
- Cooling
- Displays
- Electronic modules
- A/D and D/A converters
- Audio
- Barcode readers
- CAN converters
- Converters USB - UART / RS232
- Data logger
- DDS/PLL generators
- Digital potentiometers
- Encoders
- Expanders of the I/O
- Fingerprint readers
- HMI modules
- Image and video
- JTAG accessories
- Keyboards, buttons
- LED drivers
- Memory card readers
- Memory modules
- Modules with power outputs
- Motor controllers
- Power modules
- RS485 converters
- RTC modules
- Servo Controllers
- TSOP infrared receivers
- USB Converters - I2C / 1-Wire / SPI
- Voltage converters
- Gadgets
- GPS
- Intelligent clothes
- LED - diodes, displays, stripes
- Luminous wires and accessories
- Memory cards and other data storages
- Passive elements
- PC accessories
- Printers
- Prototype boards
- Semiconductors
- A/C converters (ADC)
- Analog systems
- Audio systems
- Bridge rectifiers
- Button
- D/A Converters (DAC)
- DDS synthesizers
- Digital circuits
- Diodes
- Drivers of motors
- DSP microprocessors
- Energy counters
- Energy harvesting
- ESD security
- IGBT drivers and bridges
- Interface systems
- LED drivers
- Logic converters
- Memory
- Microcontrollers
- Optotriacs and optocouplers
- Other
- PLL generators
- Power systems
- Programmable systems
- Resetting systems
- RF systems
- RTC systems
- Sensors
- SoC systems
- Timery
- Touch sensors
- Transistors
- Sensors
- Accelerometers
- Air humidity sensors
- Air quality sensors
- Current sensors
- Distance sensors
- Flow sensors
- Gas sensors
- Gyroscopes
- Hall sensors
- Humidity sensors
- Infrared sensors
- Light and color sensors
- Liquid level sensors
- Magnetic sensors (compasses)
- Medical sensors
- Motion sensors
- PH sensors
- Position sensors
- Pressure sensors
- Pressure sensors
- Reflection sensors
- Sensors 6DOF/9DOF/10DOF
- Sensors of liquid quality
- Temperature sensors
- Vibration sensors
- Sound transducers
- Switches and buttons
- Cables
- INTERNET OF THINGS (IoT)
- MECHANICS
- POWER
- R/C MODELLING
- RASPBERRY PI
- Accessories for Raspberry Pi
- Audio video cables for Raspberry Pi
- Case Raspberry Pi
- Cooling for Raspberry Pi
- Displays for Raspberry Pi
- Extension modules for Raspberry Pi
- Memory cards for Raspberry Pi
- Power for Raspberry Pi
- Raspberry Pi 3 model A+
- Raspberry Pi 3 model B
- Raspberry Pi 3 model B+
- Raspberry Pi 4 model B
- Raspberry Pi 400
- Raspberry Pi 5
- Raspberry Pi cameras
- Raspberry Pi Compute Module
- Raspberry Pi model A/ B+/2
- Raspberry Pi Pico
- Raspberry Pi prototyping
- Raspberry Pi Zero
- Raspberry Pi Zero 2 W
- RETIRED PRODUCTS
- ROBOTICS
- SALE
- SOFTWARE
- STARTER KITS, PROGRAMMERS, MODULES
- Alchitry FPGA
- Altera FPGA
- Analog electronics
- Atmel SAM
- Atmel Xplain
- AVR
- Banana Pi
- BeagleBone
- chipKIT
- Coral
- CPLD Xilinx
- Cubieboard
- DFRobot FireBeetle
- Feather
- Freedom (Kinetis)
- FriendlyELEC
- HummingBoard
- Intelligent clothes
- Kit with a book
- LattePanda
- LPC (NXP)
- M5Stack
- Micro:bit
- Nvidia Jetson
- Odroid
- ODYSSEY
- Orange Pi
- Other development kits
- Peripheral modules
- PIC
- Raisonance
- Raspberry Pi RP2040
- RFID
- RISC-V
- SBC Embest
- SBC MYIR
- SBC others
- SBC UDOO
- Segger programmers
- SoMLabs
- Sparkfun MicroMod
- STM32
- STM32 Discovery
- STM32 MP1
- STM32 Nucleo boards
- STM8
- Teensy
- Universal programmers
- WRTNode
- Xilinx FPGAs
- WORKSHOP
- Adhesives and gluers
- Anti-static mats (ESD)
- Chemistry
- CNC milling machines
- Crimping tools
- Dispensing needles
- Drills
- Files
- Generators
- Handles, magnifiers
- Heat-shrink tubing
- Insulation strippers
- Keys
- Knives and scissors
- Laboratory power supplies
- Laminates
- Measuring devices
- Mikroskopy
- Mini drills and grindrers
- Organizers
- Oscilloscopes and accessories
- Pliers and pincers
- Power tools
- Riveting tools and rivets
- Screwdrivers
- SMD Accessories
- Soldering
- Tapes (aluminum, kapton, copper, insulating)
- Tweezers
- Ultrasonic cleaners
- Vices
- 3D PRINTING
New products
New products
zł40.15 tax excl.
Module with a motion sensor that uses the Doppler effect to detect moving objects using microwaves. It is powered with the voltage of 5 V and has a digital output (Gravity connector). DFRobot SEN0192
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
Module with a motion sensor that uses the Doppler effect to detect moving objects using microwaves. It allows you to make precise measurements that are resistant to the influence of temperature, humidity or light. The sensor is also immune to radio frequency interference. The emitted wave has low power and is harmless to humans. This type of sensor is widely used in industry and transport to measure vehicle speed, liquid level or to automatically detect door movement. The module is powered by 5 V and has a digital output (Gravity connector). The Wiki page contains the manual and sample programs.
Features
- Interface: 3-pin Gravity interface (digital)
- Emission parameters:
- Detection distance: 2 to 16 m
- Emission frequency: 10.525 GHz
- Frequency fine setting: 3MHz
- Output power (minimum): 13 dBm EIRP
- Harmonic emission: <-10dBm
- Average current (5% DC): 2 mA
- Pulse width (min.): 5 us
- Charging cycle (min.): 1%
- Reception parameters:
- Sensitivity: (signal to noise ratio 10 dB) 3 Hz to 80 Hz
- Bandwidth: -86 dBm
- Band contamination from 3 Hz to 80 Hz: 10uV
- Antenna gain: 8 dBi
- Vertical 3dB beamwidth: 36°
- Horizontal 3dB beamwidth: 72°
- Voltage: 5V
- Current: 60 mA
- Size: 48.5 x 63 mm
Kit contains
- Digital Microwave Sensor
- Gravity cable
You might also like
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
Board with ATmega1280 microcontroller from the AVR family, the user has 54 I/O lines, 14 PWM channels, 16 analog inputs. DFRobot DFR0003
No product available!
Set of 10 cables, 30 cm long, for digital sensors compatible with the Gravity standard. DFRobot FIT0011
Other products in the same category (16)
Module with an incremental encoder with a rotation range of 360°. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020001
Module with an optical flow sensor PMW3901. It uses a low resolution camera to detect surface movement. It communicates via the SPI interface. Pimoroni PIM453
A sensor for measuring the wind speed. It has a built-in Hall sensor and enables measurements in the range from 0 to 32.4 m/s. DFRobot SEN0483
A digital shock sensor that detects hand shake. The spring-type vibration switch allows you to output pulses when the user shakes once in a certain direction. DFRobot SEN0289
Module with a gesture sensor PAJ7620U2, which allows to recognize up to 13 gestures. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020083
Module with a human presence and movement sensor designed based on the STHS34PF80 infrared sensor. Enables monitoring of radiation and ambient temperature within an 80° field of view. The sensor can precisely detect movement and presence within a range of 4 m. It uses the I2C or SPI interface for communication and has built-in Qwiic connectors. SparkFun SEN-22494
Doppler radar module with 24GHz BGT24LTR11 transceiver. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 109020021
Doppler radar module with 24GHz transceiver. It allows for precise distance measurement and motion detection. The board communicates via the UART interface. Seeed Studio 101990883
PIR infrared sensor. Reacts to the change of infrared radiation. Range up to 7m.
The plate allows the detection of gestures, similar objects at a distance of a few to several centimeters and the intensity of ambient light, equipped with an APDS-9960 system with an I2C interface. MOD-66
A small module with a PAJ7620U2 gesture detection sensor. Can recognize up to 13 gestures. Communication via the Gravity I2C interface. DFRobot SEN0315
No product available!
Digital sensor for measuring accurate and drift-free angular displacement. It is constructed from highly durable medical-grade silicone elastomers. It communicates via an I2C interface. SparkFun SEN-15244
No product available!
A set with a Doppler radar module and an XIAO ESP32C3 board designed for precise detection of human presence. It allows you to connect additional Grove sensors (analog or with an I2C interface) and expand the functionality. Seeed Studio 110061541
The GR10-30 sensor module, which can recognise up to 12 user gestures from a distance of up to 30 cm. It supports communication via both UART and I2C interfaces. DFRobot SEN0543
A module with a motion sensor that uses microwaves to detect moving objects. It is powered with the voltage of 5 V and has a digital output. DFRobot SEN0521
Pmod PIR is a module with a PIR motion sensor (EKMC1601111), which allows you to detect motion up to 5 meters from the module. The sensor during operation is characterized by low power consumption. Digilent 410-389