Category: STARTER KITS, PROGRAMMERS, MODULES

Adafruit 2010

35 W offline LED driver for 4 channels HB RGGB LED based on L6562A.

Module of the 3-axis LIS2DH, I2C accelerometer. DFRobot SEN0224

The Lattice LCMXO2-1200ZE-P1-EVN kit enables quick startup with MachXO2 devices, offering a complete set of test functions and communication interfaces. It is ideal for learning PLD logic design, testing I²C and SPI buses, and implementing control and measurement applications.

A module with a high precision temperature sensor based on the MCP9808 chip. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5027

GPS Receiver, Digilent, RoHS

The SparkFun Roshamglo is the new and fun way to play Rock-Paper-Scissors with your friends! The board uses the ATtiny84, and has an IR LED and receiver to communicate between badges. KIT-14130

Development kit with nRF52840 microcontroller with ARM Cortex M4F core and 2 MB external QSPI memory. It has built-in BLE communication. It can be programmed using the Arduino IDE or CircuitPython. Adafruit 45481

Robot controller dedicated to Totem sets. It is based on the ESP32 chip (WiFi and Bluetooth module), equipped with a DC motor and servo driver, RGB diodes and an IMU sensor. With DC adapter and Li-Ion battery. Totem TE-X4-KIT3

DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112

A power adapter that provides a stabilized supply voltage to the target board (can be adjusted from 3.6V to 0.8V). Segger Target Supply Adapter (8.06.18)

The P-NUCLEO-IKA02A1 evaluation pack provides a reference design for various electrochemical sensors

Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16445

Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16446

The STM32 Nucleo-64 boards provide an affordable and flexible way for users to try out new concepts and build prototypes with the STM32 microcontrollers, choosing from various combinations of performance, power consumption and features

DEV-14213

M5Stack Cardputer – a card-sized portable computer with an M5StampS3 module, Wi-Fi, BLE, keyboard, and TFT screen. Perfect for IoT and automation. M5Stack K132

PmodOLED - Organic LED Graphic Display

An adapter dedicated to programming STM32 microcontrollers in QFP100 chassis. It has a 20-pin JTAG/SWD connector and/or a 4-pin USART1 interface for programming and testing. Waveshare STM32-QFP100

This IoT board in the Feather format is designed for use with Li-Ion/LiPo batteries and solar panels. Equipped with a dual-core Xtensa LX7 processor, it offers Wi-Fi and Bluetooth 5 LE + Mesh connectivity, and low power consumption in deep sleep mode. The board features intelligent power management, solar charging support, numerous communication interfaces, and full compatibility with FeatherWing and STEMMA QT.