Category: Peripheral modules
Subcategories
There are 966 products.
Module allowing collision / vibration detection (based on the MVS0608.02 system). Permitted to detect collisions irrespective of direction, provides high stability and is highly sensitive. The module has a connector in accordance with the Grove standard. Seeed studio 101020005
GPIO expansion module designed for FireBeetle boards. It is equipped with a set of connectors to facilitate the connection of sensors. DFRobot DFR0483
A volume sensor designed to detect loud ambient sounds. The module uses a microphone and LM2904 amplifier. The output value (analog signal) depends on the volume of the detected sound. In order to eliminate interference, the microphone signal is subjected to double filtering. Seeed studio 101020063
Module with a slide potentiometer. Depending on the position of the slider, the resistance value (maximum resistance 10kΩ) changes, which translates into the voltage value at the analog output of the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020036
The module with a TA12-200 current sensor with a measuring range of alternating current up to 5 A. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020027
A small module with a temperature sensor (thermistor). As the temperature changes, the resistance of the thermistor changes, which allows the temperature to be measured in the range from -40 to 125 ° C with an accuracy of 1.5 ° C. The module has a connector in accordance with the Grove standard. Seeed studio 101020015
Module with a temperature and humidity sensor based on the SHT31-D system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 2857
Vibrating sensor module, Plug & Play, omni-directional, designed for switching over low-current circuits. DFRobot DFR0027
Module of the 3-axis LIS2DH, I2C accelerometer. DFRobot SEN0224
Module with 3-axis accelerometer and gyroscope LSM6DSV16X. The chip is a low-power IMU optimized for IoT devices with data processing capabilities using machine learning. Equipped with a Qwiic connector, it communicates via the I2C interface. SparkFun SEN-21325
Class D stereo sound amplifier based on the Texas Instruments TPA2016D2 circuit. It can work with 4 Ω speakers with power up to 2.8 W or 8 Ω with power up to 1.7 W in stereo mode. SparkFun DEV-20690
A push-button module with RGB LED backlighting. The board is equipped with a Gravity connector and communicates via an I2C interface. DFRobot DFR0991
LPS28DFW absolute pressure sensor module. The chip features a wide measurement range of 260 to 1260 hPa or 260 to 4060 hPa and a high accuracy of 0.5 hPa. It communicates via an I2C interface. SparkFun SEN-21222
BMA400 3-axis accelerometer module with a measurement range of up to ±16g. The board is equipped with a Qwiic connector and communicates via an I2C or SPI interface. SparkFun SEN-21208
GPS module with SAM-M10Q GNSS receiver. The chip can receive data from all major positioning systems: GPS, GLONASS, Galileo, QZSS and BeiDou. It has derived UART and I2C interfaces. SparkFun GPS-21834
Module with 3-axis accelerometer and ISM330DHCX gyroscope. Equipped with a Qwiic connector, it communicates via the I2C or SPI interface. SparkFun SEN-19764
