Best sellers

Module with five reflection sensors. It has digital and analogue outputs. Thanks to the embedded EEPROM memory, it enables easy sensor calibration. Cytron Maker Line

Easy-to-use USB-to-Serial adapter based on the CH340G IC from WCH; works with 5V and 3.3V systems and should auto install on most operating systems without the need for additional drivers; uses the CH340G IC to quickly and easily convert serial signals to USB. DEV-14050

Single-channel DC motor controller that allows the motor to be controlled with a voltage range of 6-30V and a current of up to 20A. Allows engine speed control using PWM signals. MD20A cytron

Module with slot optical sensor TCUT1600X01. The board is equipped with a Grove connector and has two digital outputs. Seeed Studio 101020587

Module with LED driver. It can control LED strips with a length of 1 to 2 meters at a voltage of 9 V or from 1 to 5 meters at a voltage of 12 V. Seeed Studio 105020002

ARM Cortex-M4 MCU, 128 KB Flash, 128kB SRAM, 84 MHz CPU, DSP with FPU, Art Accelerator, LQFP100, STM, RoHS

The module with the MAX31850K amplifier is designed to work with a thermocouple. The board is equipped with a Grove connector and communicates via 1-Wire. Seeed Studio 101020555

ARM Cortex-M3 CPU, 256kB Flash, 64kB RAM, Ethernet, USB OTG FS, 2xCAN, 5xUART, 2xI2C, 2xSPI, ADC, DAC, STM, LQFP64, RoHS

Module with 4-digit 7-segment display with red digits. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020044

CAN module based on MCP2551 and MCP2515 systems with an OBD-II compatible connector. It uses the I2C or UART bus (Grove connectors) for communication. Seeed Studio 103030215

0.31 Mpx camera module with OV7251 sensor compatible with all versions of Raspberry Pi. The maximum video resolution is 640×480 pixels. ArduCAM B0161

Module with pressure and temperature sensor BMP280. The board is equipped with a Grove connector and communicates via the I2C or SPI interface. Seeed Studio 101020192

A module with a microSD card slot for Arduino. Equipped with two Grove connectors with I2C and UART for connecting additional sensors. Seeed Studio 103030005

Module with the SLA-05VDC-SL-C relay with a maximum load of 30 A. The board is equipped with a Grove connector and is controlled by a digital signal. Seeed Studio 103020012

Development board with ATmega4809 microcontroller and Microchip ECC608 cryptographic chip. It is equipped with 6 analog input pins, 14 digital inputs/outputs (5 as PWM output) and Grove ports. Seeed Studio 102010288

8 Mpx camera module with IMX219 sensor. The camera is intended for use as a replacement on the RPI Camera Board V2. ArduCAM B0180

LoRa MESH Radio Module is a radio module with an operating frequency of 868MHz. Communication with the module takes place via the UART serial interface. It has a range up to 3km. It is supplied with voltage in the range of 3.3-5V. DFRobot TEL0117

8 Mpx camera module with IMX219 sensor with low distortion lens. The camera is intended for use as a replacement on the RPI Camera Board V2. ArduCAM B0184

THERMOSTAT - PLATE AND PROGRAMMED SYSTEM

Module with minicamera based on IMX219 matrix with 8 MPx operation for Nvidia Jetson Nano, with 300 mm tape. ArduCAM B0185