OP2000-5 - 2000X tip for SigOFIT Micsig probe

Oscilloscope probe designed to analyze signals generated by the ignition coil in car engines. It is compatible with most digital oscilloscopes. Hantek HT20COP

6-wire test leads that allow the oscilloscope to be connected to various components in the engine compartment without stripping or puncturing the insulation and without risking damage to the connectors. Hantek HT306-2.8mm

Oscilloscope probe designed to analyze signals generated by the ignition coil in car engines. It is compatible with most digital oscilloscopes. Hantek HT25COP

A universal oscilloscope probe with a BNC connector and a 10:1 voltage divider. It has a frequency response of 60 MHz and allows measurements with a maximum voltage of up to 600 V. Hantek PP-80

Test probe tip with 20X attenuation factor. Dedicated to Micsig probes from the SigOFIT series operating in the 800 MHz and 1 GHz frequency band. Micsig OP20-1G

Product available on request. Please send your inquiry to the following address: sales@kamami.com

A 20:1 signal attenuator designed to assist in measuring automotive performance, including measuring fuel injector and primary ignition runs. Hantek HT201

Test probe tip with 1000X attenuation factor. Dedicated to Micsig probes from the SigOFIT series operating in the 800 MHz and 1 GHz frequency band. Micsig OP1000-1G

Product available on request. Please send your inquiry to the following address: sales@kamami.com

High-voltage differential probe. It has good measurement characteristics: a bandwidth of 100 MHz and an operating voltage of up to 1300 V. The probe has two attenuation coefficients: 50X and 500X. Hantek HT8100

Insulated fiber optic probe with a measuring range up to 2500 V. It works in the band up to 200 MHz, it can be connected to the oscilloscope via the BNC connector. Micsig MOIP02P

Product available on request. Please send your inquiry to the following address: sales@kamami.com

Micsig MDP series differential probe based on advanced SigOFIT technology. It offers a frequency band of 150 MHz and the ability to measure voltage up to 3000 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig MDP3001

Insulated fiber optic probe with a measuring range up to 2500 V. It works in the band up to 100 MHz, it can be connected to the oscilloscope via the BNC connector. Comes with a 10X attenuation tip. Micsig MOIP01P

Product available on request. Please send your inquiry to the following address: sales@kamami.com

Insulated fiber optic probe with a measuring range up to 2500 V. It works in the band up to 350 MHz, it can be connected to the oscilloscope via the BNC connector. Comes with a 10X attenuation tip. Micsig MOIP03P

Product available on request. Please send your inquiry to the following address: sales@kamami.com

Oscilloscope probe designed for the analysis of signals generated by the ignition coil in automotive engines. It is compatible with most digital oscilloscopes. Hantek HT25

Probe for measuring direct and alternating current up to 30 A. Works in the band up to 100 MHz, can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP1003B

The housing for the DSO138 oscilloscope allows for easy storage and mobile use of the device. It protects the PCB and any microcircuits on it from dirt or accidental damage.

Micsig MDP series differential probe based on advanced SigOFIT technology. It offers a frequency band of 150 MHz and the ability to measure voltage up to 700 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig MDP701