Category: Electronic modules

5.0V Power Supply Module Board with Red Indicators, AMS1117-5.0V, RoHS

TTL - RS485 converter 5V. RS485 interface on 5.08mm screw terminal and 2.54mm pitch connector.

USB-RS485 converter for industrial applications. It provides communication between the USB interface and the RS485 serial standard. Waveshare USB TO RS485

3.3V Power Supply Module Board with Red Indicators, AMS1117-3.3V, RoHS

Compact module with MOSFET IRF520 24V/5A transistor.

Module with a 12 V relay and a timer. It allows you to turn the device on and off cyclically at a specified time using potentiometers. It can also operate in single trigger mode, which allows the device to be turned on after a signal has been applied for a specified period of time. The operating time can be adjusted from 1 s to 100 s or from 1 s to 15 min

150 W Step-Up converter with an output voltage of 15to 35 V, an input voltage of 10 to 32 V and a maximum current of up to 6 A

The adapter allows to extend the CSI / DSI interface using two FFC tapes (by connecting them in one tape). It allows you to connect the camera to a Raspberry Pi computer or a DSI display, for distances using two FFC tapes. Adafruit 3671

Frequency generator module with Si5351 chip based on 25 MHz quartz. The system has three independent, programmable clock outputs that can generate a clock signal in a wide range from 8 kHz to 160 MHz

Module of a stereo 24-bit audio converter with I2S interface (TS4657).

Adjustable proximity sensor E18-D80NK allows detection of the object at a distance of 3 - 80 cm. Detection of an obstacle occurs due to the appearance of reflected infrared light.

DS18B20 compatible temperature sensor in a waterproof stainless steel housing, RoHS

Step-Down converter module with input voltage from 4.75 to 23V, output voltage from 1 to 17V and output current 1.8 A (3 A instantaneous current).

UART-CAN converter module based on the TJA1050 transceiver system. It allows for communication, for example, of a microcontroller via the CAN bus

Breadboard power supply module, 5V, 3.3V, RoHS

The module is equipped with an AS5600 magnetic encoder with a resolution of 12-bit. It allows for non-contact measurement of the angle of rotation. The module has an analog/PWM output and an I2C interface.

The base plate is dedicated to ESP32 CAM modules. It allows you to connect the camera via a USB interface, e.g. to a computer. ESP32-CAM-MB

Compact expansion module compatible with DRV8825 and A4988 stepper motor drivers. It allows you to connect the module with the controller and convenient connection of other system components

Relay with a control voltage of 12 V and contact load capacity of 8A/250V AC or 8A/30V DC. It is characterized by stable operation in a wide temperature range. Finder 40.52.7.012.0000

USB-CAN adapter with support for CAN2.0A and CAN2.0B standards. It can work with Windows and Linux systems, including Raspberry Pi and Jetson Nano minicomputers. Waveshare USB-CAN-A