Category: Electronic modules

UART converter module - RS-485 based on the MAX485 system. modTTL-485

USB-CAN adapter with support for CAN2.0A and CAN2.0B standards. It can work with Windows and Linux systems, including Raspberry Pi and Jetson Nano minicomputers. Waveshare USB-CAN-A

Adafruit 2094 - JTAG (2x10 2.54mm) to SWD (2x5 1.27mm) Cable Adapter Board

Industrial RS485-Ethernet converter that provides easy communication between the RS485 and RJ45 Ethernet interface. Mounted on an industrial rail. Waveshare RS485 TO ETH (B)

2-channel RS485 to Ethernet converter designed for industrial environment. It connects serial server, Modbus gateway, MQTT gateway, RS485 to JSON and network switch. It has two RS485 ports and two Ethernet ports with PoE function. Waveshare 2-CH RS485 TO POE ETH (B)

The stepper motor driver with Allegro A4988 (A4988 Stepper Motor Driver Carrier) allows you to supply a bipolar current of up to 2A per phase. The system can be supplied with voltage up to 35V, in the set there is a heat sink. It is compatible with Polol 1182

A small USB-UART TTL converter module based on the CH340E chip with a microUSB connector

Class D LTK5128 mono digital audio amplifier module. The system allows you to connect one loudspeaker with an impedance from 4 to 8 Ω and a power of 5 W

DRV8825 Stepper Motor Driver Carrier is a DRV8825 stepper motor driver that allows you to supply a bipolar current of up to 1.5 A per phase, without using a heat sink. The system can be supplied with voltage up to 45V, in the set there is a heat sink. It is compatible with Polol 2133

Programmable RGB and RGBA LED driver

Stereo audio amplifier based on the TPA3116D2 chip. It can be powered with the voltage from 12 to 26 V and has two outputs with a power of 120 W

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

Step-Up/Step-Down converter with an output voltage of 3.3 V, an input voltage from 3 to 15 V and a maximum current of up to 600 mA

ModRL01 module with 10A/250VAC (10A/24VDC) relay, supply of 5 V load relay coil, additional control circuit, protected overvoltage control

USB TO UART solution with USB Type A connector, Waveshare

The lead module for the ATX power supply has 24 pins, a switch and 4 voltage modes, providing flexibility in device testing. Its compact dimensions of 12.8 cm x 4.8 cm and built-in fuses guarantee easy installation and safe use.

Step-Down converter with adjustable output voltage from 1.25 to 36 V, input voltage from 4 to 38 V and maximum current up to 5 A

Two-way speaker crossover with a division frequency of 3800 Hz. Works with 5 to 8 ohm speakers and offers up to 120 watts of power

The ESC RC controller module is designed for brush motors with a supply voltage from 3.5 to 6 V and a capacity of 1 A