Category: Electronic modules

Module with EEPROM memory with a capacity of 256 Kbit (32 kB) with the AT24C256 chip in the DIP version. It communicates via the I2C interface

The module allows you to send UART (TTL) bus signals to a computer via a USB port. The adapter operates based on the PL2303HX chip and is recognized in the computer as a virtual serial port

Photodiode Brightness Sensor Module, RoHS

The 6V 10W USB Step-Up Converter Module converts 4.2-5.2V input voltage to 6V DC output voltage, with a maximum current of 2A and a conversion efficiency of 96%. The device can operate in a wide temperature range, from -40°C to 85°C, which makes it ideal for powering various electronic devices in harsh environments.

RS485 communication board, SP3485 on board, 3.3V

LC filter connected to the output of the DC power supply with a voltage from 0 to 25 V and a maximum current of 4 A. It reduces voltage ripple and interference caused by the power supply

The 12V 10W USB Step-Up Converter Module converts 4.2-5.2V input voltage to 12V DC output voltage, with a maximum current of 1A and a conversion efficiency of 96%. The device can operate in a wide temperature range, from -40°C to 85°C, which makes it ideal for powering various electronic devices in harsh environments.

TDA2030A mono digital audio amplifier module. The system allows you to connect one loudspeaker with an impedance from 4 to 8 Ω and a power of 18 W

Audio preamplifier module based on RC filters. Equipped with potentiometers to adjust bass, treble and volume level

Audio level indicator module. It is based on the KA2284 chip and has 5 LEDs in yellow, red and green

Class D mono digital audio amplifier module PAM8302. The system allows you to connect one loudspeaker with an impedance from 4 to 8 Ω and a power of 2.5 W

The current measurement with the value 0-20A is carried out by the ACS712-05 system based on the Hall effect. The sensitivity of the system is 100mV / A (analogue signal) .modACS712-20

The MQ-4 sensor allows methane concentration measurement. The measuring range of the sensor reaches up to 10,000 ppm and an analogue signal is obtained at the output.

USB TO UART solution with USB Type A connector

PIR - infrared sensor module, motion sensor, range 6m, RoHS modHC-SR501

4-channel converter of voltage levels 3.3V/5V that allows you to connect systems operating at a lower voltage to those powered by a higher voltage

Real time clock (RTC) module dedicated to Raspberry Pi. Based on the Dallas DS3231 chip, it has a built-in backup battery

Module with 4-channel ADC ADS1015 converter. The system enables analog voltage conversion for single signals and differential signals with 12-bit resolution. I2C communication

Camera for Raspberry Pi minicomputers. Works with all versions of minicomputers with a CSI socket. The camera is equipped with a Sony IMX477R sensor with a resolution of 12.3MPx and a built-in IR filter. Raspberry Pi HQ Camera

Power module (shield) designed for Wemos D1 Mini boards