Category: Gravity peripheral modules (DFRobot)
There are 247 products.
A digital precision current sensor module that measures voltage, current and power of electronic modules and devices up to 26V and 8A with a relative error of ± 0.2%. DFRobot SEN0291
A 24-channel input/output port expander module controlled by an I2C interface. It was based on the CH423 chip and equipped with a Gravity connector. DFRobot DFR0979
This V2 Rotation Sensor is arduino compatible multi-ring rotation sensor. It is based on multi-turn precision potentiometer. It can rotate upto 10 laps. DFR0058
DFRobot Gravity analog light intensity module for Arduino and Raspberry Pi. DFRobot DFR0026
A set of 10 cables, 50 cm long, compliant with the Gravity standard. DFRobot FIT0773
Soil moisture sensor with analog output. The probe has two pointed tabs, making it easy to insert into the ground. It is supplied with the voltage of 3.3V or 5V. DFRobot SEN0114
Digital orientation sensor module. DFRobot DFR0028
Module with 5 A 250 VAC relay. DFRobot DFR0017
VL53L0X ToF Laser Range Finder is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is supplied with 3.3 ... 5 V voltage and can measure up to 2 m. DFRobot SEN0245
2x1.2A DC Motor Driver is a dual controller of DC motors with a Gravity connector, supplied with 2.5 ... 12V voltage with a maximum current consumption of 1.2A (3.2A peak) per channel. DFRobot DRI0044-A
Module with 6-axis BMI160 motion sensor (accelerometer and gyroscope) with 16-bit data resolution. It is supplied with the voltage in the range from 3.2 to 6 V. I2C communication. DFRobot SEN0250
Gravity: Vibration Motor Module is a module with a small vibration motor powered by 5V voltage, controlled by a binary signal (high / low state) or using a PWM signal. DFRobot DFR0440
Gravity: Digital Crash sensor is a microswitch module (left) often called a limit switch. The module is powered by 5V voltage and has a digital two-state output. DFRobot SEN0138-L
Module with a motion sensor that uses the Doppler effect to detect moving objects using microwaves. It is powered with the voltage of 5 V and has a digital output (Gravity connector). DFRobot SEN0192
Gravity sensor adapter with 3-pin terminal connector. There are two 10 kΩ pull-up and pull down resistors on the board, set with a jumper. DFRobot DFR0055
Module with an analog MQ8 hydrogen sensor. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0133
8-digit, 8-segment LED display module with 16-level brightness adjustment. Communication via the I2C interface. DFRobot DFR0646-G
Module with a digital temperature and humidity sensor based on the SHT31-F system. Communication via the I2C interface. Equipped with a Gravity DFRobot SEN0334 connector
NFC module with built-in antenna on the board. The module has a Gravity connector. Memory communication can be done through one of the serial interfaces: UART or I2C. DFRobot DFR0231-H
Gravity: Analog TDS Sensor / Meter is an analog water purity measurement module. It is powered by 3.3 ... 5.5V voltage and has an analogue output interface. Module compatible with Arduino. DFRobot SEN0244