BIGTREETECH IO2CAN V1.0 - CAN module for Raspberry Pi and CB1

USB - LIN bus converter module. It allows you to connect devices to your computer via the LIN bus. LIN USB CONVERTER (LUC)

RS485 CAN HAT is an extension designed for the Raspberry Pi mini-computer in the form of a HAT overlay. Adds RS485 and CAN interfaces for the Raspberry Pi plate. Interface signals are derived as screw and goldpin connectors. RS485 CAN HAT

Industrial server with a CAN, RS485 and Ethernet port that allows communication between CAN devices and the network server. It has built-in 2 CAN channels, 1 Ethernet port and a TCP/IP stack. It is enclosed in a metal housing with an industrial design. Waveshare 2-CH-CAN-TO-ETH

The USB-FDCAN converter is a device that enables communication between the computer and the CAN (Controller Area Network). It supports the CAN FD standard and is equipped with a Microchip MCP2542FD transceiver. FDCAN USB converter

TTL/CAN-USB converter dedicated to distance sensors TF03, TF02 and TFmini with TTL/CAN interface. Comes with a miniUSB cable. Benewake TTL/CAN to USB converter

Communication module with CAN-UART converter and USB 1.0 interface. It supports CAN 2.0 protocol and supports SLCAN. It is operated using AT commands. DFRobot TEL0150

UART-CAN converter module based on the TJA1050 transceiver system. It allows for communication, for example, of a microcontroller via the CAN bus

KAmod CAN-TXRX is a CAN bus transceiver with the MCP2542FD system, compatible with the CAN 2.0 and CAN FD standards, enabling sending and reading data with the serial interface voltage level adjustable in the range of 1.7...5 V, equipped with protections and LEDs signaling action

An extensive CAN to Ethernet converter adapted to difficult industrial conditions. It supports two CAN interfaces, one Ethernet interface and a TCP/IP protocol stack. It also has one RS485 serial port. USR-CANET200

The CAN transmitter and receiver module is intended for M5Stack sets. It is based on an isolated CA-IS3050G transceiver system, which can provide differential data reception and transmission. M5Stack U085

I2C-CAN converter using the MCP2551 and MCP2515 systems and the ATmega168PA microcontroller. The module uses the I2C bus and the Grove connector for communication. Seeed Studio 113020111

CAN module based on the SN65HVD230 system, allows you to connect a microcontroller with a CAN bus interface

RS232/485/422 to CAN converter enabling conversion and communication between RS232, RS485, RS422 interfaces and the CAN interface. It supports the Modbus RTU protocol, has numerous built-in protections, and the metal housing facilitates installation in an industrial environment. Waveshare RS232/485/422 TO CAN

KAmodRPI RS485 CAN HAT is a shield for the Raspberry Pi computer that extends its interfaces with RS485 and CAN. Bus signals are led out to goldpin connectors and terminal blocks.

A set of necessary tools needed to perform vehicle diagnostics. It consists of a CAN Bus module, an OBD II connector and the necessary wires. Seeed Studio 114991438

The CAN-BUS Arduino Shield v2.0 can be stacked on an Arduino UNO, Arduino Leonardo or Arduino MEGA board. The shield integrates an MCP2515 CAN-BUS chip on the shield and has a CAN-BUS transceiver function. With an on-board DB9 and CAN-BUS connector you can choose a suitable port according to your host device. There is also an integrated MicroSD socket for data storage. DFR0370